60 watts bulb and resistor home heater is connected in
series and 230v is given to the circuit. The heater is
giving some amount of heat. If instant of 60 watts bulb
replace 100 watts bulb what will be the output of the heater?
Answer Posted / vinod
output of heater will be more as 100 w bulb has less
reistance copared to 60 w
| Is This Answer Correct ? | 14 Yes | 0 No |
Post New Answer View All Answers
What are the types of the glands and difference between single and double compression type of cable Glands.
why dimmerstate always connected in star connection? what will happen if it connected in delta?
how to test power transformer.YNd11
How to select batteries required for ups and the inverter if we Known load? And how AH is selected of battery?
What is A check, B check, C Check & D check for a diesel Generat
What is the formula to calculate the no load current of a single & three phase induction motor
use of choke in APFC panels
what is a power factor?
Whats the minimum value for I.R. that can be allowed for HT & LT alternators for operation?
What is main cause of cable's terminal point burned in Lug on high temperature although lug and cable selection is ok as per stantard and also tightness is ok as per situation. so please take in deep and tell correct answer thanku.
what mean by analog ,digital,numerical meters and relays? say the example?
Match the following a)(X'+Y') b)X'Y' C)XY 1)NAND 2)NOR 3)Carry
in wind mill use 2100 kw asychronous generator ( induction generator ) rotor voltage : 3300,stator voltage : 690, rpm : 1511 type : MRL063E04 ' we check rotor resistance magger value found following. R-EARTH - 00 M.OHM,Y-EARTH-34 M.OHM,B-EARTH- 33M.OHM R-Y: 31 M.OHM, Y-B: 00 M.OHM,B-R :33 M.OHM HOW CAN I TAKE DECISION?pls ans. quickly
Incoming line 11kv And transformer capacity is 2500kva. Consumption load is 1300A. Then fuse capacity is 11kv line.
how the testing of protection CT Testing done through Primary injection kit please describe in detail procedure...