why we not connect the 12 V batteries in parallel to get the more backup suppl

why we not connect the 12 V batteries in parallel to get
the more backup supply for an UPS ? wheter off line or on
line UPS ?

Question Posted / dineshdesh

2 Answers
4927 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

why we not connect the 12 V batteries in parallel to get the more backup supply for an UPS ? whete..

Answer / romeovictoriano

Arranging batteries in series is to configure the required
voltage. After configured the required voltage by series
connections a parallel connections of the series connected
batteries is arranged to a limit that it will not induce
overcurrent to UPS System, otherwise it will cause
overcurrent and damaging UPS System.

Is This Answer Correct ?

2 Yes

0 No

why we not connect the 12 V batteries in parallel to get the more backup supply for an UPS ? whete..

Answer / k.prakashchandra

back up time depends on storage in batteries =VxAH.In
series voltages add up and in paralllel AHs add up

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

What are the RGGVY, APDRP, RE?

3 Answers

why we decide alternating wave form in ac system and not in dc system

2 Answers GMR,

How much width of the land shall have to be left below the EHT line of 440 kv as per the rule. i am told that a corridor of 35 M width is to be left free below 220 kv line. please confirm

1 Answers

What is the function of NGR for the parallel operation of alternator? whats happen when different rating of alternator are running with parallel?

0 Answers Welspun,

If the kvar rating of capacitor bank is 600 kvar at 525V then what it's rating at 415v.

2 Answers

What was your role in the silicon evaluation/product ramp? What tools did you use?

0 Answers Intel,

why distribution transformer are of DY11 type?

4 Answers

If I want to replace a 26KW Slip ring Motor with a Squirrel Cage motor & Drive (for a Hoist Application). How can I approximate the Motor & Drive HP required in new Setup.

0 Answers

. Draw the vector diagram and condition for the following: 1) Dyn1 2) Ynd0 3) YnYn0

1 Answers

sir, iam a electrical engg graduate and i want to go in automation sector and for this i have decided to do industrial training for this,plz suggest me some good institute for the same in delhi,ncr. my degree percentage is 58%, can i get job after doing training, plz help....

0 Answers

in the case of 6.6kv motor starter combination contain fuses on it VCB. but in 11KV motor starter combination Fuses are not using in it's VCB why?

0 Answers

What is technical difference between ELCB & ELMCB?

3 Answers

For more Electrical Engineering Interview Questions Click Here