1 “earthing” for bonding of equipment and circuits to common plant earth electrode potential,
2 “protective earthing (PE)” when this bonding is required for personal safety provisions
3 “grounding” for interference suppressing bonding of screens, sys-tems with ground level
4. low-impedance earthing ?
5.primary earthing system and secondary earthing system what is that?
6.earthing electrode or mesh net earthing electrode ?
very confusing , simple but very informative help required ?
i will be very very thankful to you guys.
No Answer is Posted For this Question
Be the First to Post Answer
Do you know what is dry-out test in x'mer
0 Answers First American Corporation, GPSC Gujarat Public Service Commission, Jindal,
what is KWH
Why transformer rating in KVA? describe.
Write the formula for Fault MVA, Fault current, Base MVA.
What is resolution of a measurement?
what is the impedance voltage of transformer?
1 Answers AVI Enterprises, MacLellan,
what is servo motor principle? difference between induction motor & servo motor?
why capacitor using the induction motor?
Which type of control system is expensive — closed loop or open loop?
The inexpensive way to improving energy efficiency of a motor which operates consistently at below 40% of rated capacity is by _____.
what happens if DG N earthing fails while running and N Earthing fails while Transformer on load ???what will be the impact ???????/
What is your acheivements
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)