Answer / swati saxena

The term is generally used to describe relay (electrical switchgear) characteristics. IDMT relays have such tripping characteristics that, for a particular range of low values of current the tripping time varies inversely with the value of current. But beyond a certain current limit the tripping time becomes constant(definite) and causes tripping in minimum time. Hence the name Inverse/Definite Minimum Time. This type of characteristic is found in Over current Relays.

Answer / pinaki chatterjee

TO PROTECT THE SYSTEM THE TRIPPING ARRANGEMENT IS SUCH IN
THIS CASES THAT WHEN THE FAULT CURRENT WILL INCREASE THEN
THE TIME TAKEN WILL BE IN REVERSE MANNER , MEANS MUCH LESS
THAN BEFORE THAT WILL TAKEN THE TIME, IN SENCE THE NAME
IS INVERSE DEFINITE MINIMUM TIME RELAY.

Answer / najmul

it is inverse define time relay. its working to fault
measurement inversely.fault current increase to operating
time decrease.

Answer / anil

inverse defenet minimum time relay
having inverse characteristics

Answer / anil

it is a over current protection relay

What is slope...? Explain slope 1 and slope 2...?

0 Answers  

what is the basis for selection of Protection CT class ? How anyone can decide whether to go for 5P10 or 5P20 ?

3 Answers  

what is NGR in generator?

4 Answers  

What's the difference between a generator using 50Hz and 60Hz? When do we need to use a generator 50Hz and 60Hz?

3 Answers  

why test lamp didn't glow across 500v megger?

4 Answers   Aurobindo,

In power transmission using open belts or horizontal shafts it is preferable to have the slack side of the belt on the top because

0 Answers   Caterpillar,

PLZ SEND ME SOME UNIQUE PROJECT OF ELECTRICAL ENG (B.TECH)

0 Answers  

Natural frequency of a system gives... 1) nature of transient 2) overshoot 3) oscillations 4) speed of response

1 Answers   CCP,

what is the diffrence between capasitor and battery?

2 Answers  

Is there any Flood lighting system which produces more light (More power consumption 1000W,400W etc.,), white light and restart immediately after power restoration ?

1 Answers  

what are the protection equipments used betbeen HT line and transformer in a power plant

4 Answers  

While connecting the flood light plug on to the 415 V distribution panel,there was spark and the cable got burnt. Three ignitors of the flood light also burnt of. The lamps are of 400 W (total 6 lamps) connected through 1.5 mm2 cable. The plug was immediately removed from the circuit. There was a 30 mA RCD connected and a 250 A MCCB; however both did not trip. What could be the possible reasons for the circuit devices not to trip?Can someone assist please. Additional info if needed can be provided.

2 Answers