Answer / chalapathi

There is shunt resistor in Meger total current flow through
that resistor, the shunt resistor is connected parrele to
meger connecting probes

Answer / vasudevan.m

Megger normally operate in DRY CELL ( Digital megger) or
electro magnetic induction (analog megger). so the current
flow at the output terminal of the megger is very very low
which is not sufficient to make the lamp to glow.

Answer / k.prakashchandra

It has a high series resistor

Answer / guest

lamp is working on 3 phase supply

What happened if C.T mount at any cable or Bus bar in wrong direction . C.T going on proper work or not . C,T direction is essential thing to properly work.

0 Answers  

---

Write the force balance equation of ideal spring element.

0 Answers  

---

If we touch the Capacitor terminals you feel shock after the capacitor was put in operation and not in case of inductor though both are energy storage elements.why?

4 Answers   HAL,

---

The earth pin of some three pin plugs are seen split. why?

1 Answers  

---

ohm's law is applicable to DC/AC/Both??

6 Answers   KPIT,

---

what is the problem when i want to close a circuit breaker by local position it closes well.but when i close it in remote position it trips

0 Answers   KPCL, MDIM,

---

What will happen if 230V DC motor connected to 230V AC Supply?

15 Answers   Ashok Leyland, BOC, JSW, ONGC, RRB, TRB,

---

which of the following is the earliest known literary source of ancient india and indeed of mankind

1 Answers  

---

when a primary current injection test is required, it is accomplished by what?

3 Answers  

---

difference between shunt coil and tripping coil

8 Answers   GE,

---

why swityard is necessrry requirement in any bis power distributin systems?

0 Answers  

---

why transformer rating is mentioned in kva?

1 Answers   JK Electric Works,

---