Answer / piyush

GANG OPERATING DEVICE

Answer / mr. suresh krishnan

Gang Operating Device

Answer / gautam makavana

in transmission line gang operating device is used to isolate and make to ckt ilke as a one type of isolator.
this is true.

Answer / azaz

gain operating device

Answer / naman tikmany

the god who trust to people is known as god they will help
us and give studies and if you tell lie god will panis us
or not give good studies.
naman tikmany
6 g
mahatma schooln [k.k.nagar second floor]

Answer / harshan

G- Generate
O- Operate
D- Distribute

What is meant by Reactor in power system and what are the uses?

11 Answers   EEE,

what is the difference b/w earthing and grounding??

2 Answers   Dodsal,

Is ground earthing required for neutral conductor of a prime mover ie DG set?

1 Answers  

1.why ACB is not connected in HT side what Happens? 2.how much voltage maintained in ACB breaker? 3.OLTC is connected in primary side in case secondary side connected what happened?

3 Answers   L&T,

What is the reason for low voltage in houses?

19 Answers   Maytas,

in single phase we get 220 volt and in three phase 4420 v why this second Ques= in case three phase star conection our neutrul becom disconect what happan 3 Q=== a three phase house load and have unbalce load on different pahse diffrent current eg phase a 7A b 8A c 5A and voltage is 440 than how calculate it total load in kw pl give formula thanks

8 Answers  

What is the difference between Rectifier & Converter?

12 Answers   Bajaj,

what size steel armoured cable is required to support 1500kva capacity. would 70mm squared be enough or would I need 90 or 120mm squared 3c plus earth

0 Answers   Conan Minerals,

In our factory there is one no. of Series trip HT 6KV OCB. 1. Is it possible to measure CT out put current by 440V Clamp meter? The measurement is required for knowing the exact value of current in CT secondary to set up protection for transformers. 2. plase forward the single line diagram of AMF panel?

1 Answers   HAL,

What should be the minimum depth of ground laid 66 kv ht cable?

3 Answers   L&T,

What is the Difference Between MCCB & ACB & VCB

4 Answers   ABB,

L&T ACB C-POWER OF 800A FAULS TRIPING AT THE TIME OF 110KW MOTOR STARTS WITH EARTH FAULT RELEASE

1 Answers   Ambuja,