Answer / madhu

By having this value we can find the Fault current of the transformer as mentioned below



              Fault current=Full load current/impedance of the transformer

what is the eight bit unit?

0 Answers  

---

Why is making current of CB always greater than CB breaking burrent?.

6 Answers   JP Group,

---

defination of lines

0 Answers  

---

What should be the voltage between Neutral and Ground in secondary side of the step down transformer (230 V to 110 V) with no load condition?

0 Answers   Jindal,

---

directional over current relay when acted & how it works

3 Answers   NCC, ThyssenKrupp,

---

What is Mvar?how significant is in electrical energy transmission?

2 Answers   Areva,

---

why magnet has north and south poles only why not east and west and why we are considering as north and south poles? why cant we consider as east and west?

0 Answers  

---

Is there any calculation to find unknwon(unferroled) phases R Y B in alternator,3 phase motor anybody shoot my problem. how can we notice this is the respective phase?

2 Answers  

---

why the measure taken in multiplication factor of 11for voltage like.. 110V,220V,440V,1.1KV,6.6KV,11KV,33KV,66KV,110KV,132KV,220KV

1 Answers   Vijai Electricals,

---

what is the formula for calculate the turns in Transformers

2 Answers  

---

WHAT IS THE FULL FORM OF ONAN ( TYPE OF COLLING IN TRANSFORMER)

7 Answers  

---

my 10 hp submersible pump is tripping when connected through ELCB.I have checked the megger value of the coil's with body.It was found to be 0.2mega ohm.that is leakage is there.But when connected to mccb it is not tripping.no leakage current in the motor.Is it safe to connect to mccb? what are the problem's will arise if future?also tell me in ELCB no neutral is connected to motor.than how ELCB was working?

1 Answers  

---