We store the d.c supply...then why can't we store A.c supply???
Answers were Sorted based on User's Feedback
Answer / naresh_alf
the reason is when A.c supply is given the atoms get
thermally vibrated and dissipating energy in the form of
heat so ther is no chance of energy storage....
while coming to d.c supply the thermally vibrations are
absent....... that is the reason we can store the D.c but
not A.c.....
Is This Answer Correct ? | 17 Yes | 7 No |
Answer / kamal kishore
We cannot store AC in batteries because AC changes their polarity up to 50 (When frequency = 50 Hz) or 60 (When frequency = 60 Hz) times in a second. Therefore the battery terminals keep changing Positive (+ve) becomes Negative (-Ve) and vice versa, but the battery cannot change their terminals with the same speed so that’s why we can’t store AC in Batteries.
Is This Answer Correct ? | 2 Yes | 1 No |
Answer / bharat singh
we cannot store ac becouse it has two half + and - so when
we store + half it will stored but when in - half it will
discharge the stored + half
Is This Answer Correct ? | 1 Yes | 1 No |
Answer / arnab
we do not store any ac or dc supply. we store only energy.
Is This Answer Correct ? | 2 Yes | 7 No |
Explain about 3 phase motor fault current calculation with examples?
Hi, Next week Iam appearing RRB exam for section engineer. So help me to get modal question papers for this position. Iam very thankful to you. Whether question will be fully techanical format or general form. Please give me a details regarding this exam.
any one guide me to reduce the power factor of diesel Generator from 0.97 Leg to 0.8 Leg.with out any change in my load.
critically criticize the application of ring main unit in power system
What is PCCB?
1 Sq.mm ( Aluminium Cable ) = How much Amphere ( AMP )
what is meant by servo motor ? how its operating either AC or DC?
I need the recommended size for a 3 phase transformer at 13.8 KV Primary and connected loads of 3000 kVA at 4200 volts and 2375 kVA @ 480 volts AC.
The capacity of the transformer is 20/25 MVA, Ratio is 132/11 KV, Vactor group YNyno. and impedance is 10.07%. As per the calculation the secondary current is 1312.2Amps. The maximum fault current the transformer should sustain is 13.030KA. How many times the transformer should sustain the maximum short circuit current of 13.030KA over a period up 1 Year. The transformer is repaired one & 10 Years old.
why DG sets power factor is 0.8 lagging.
WHAT IS ND RELAY AND HOW DOES IT WORK?
Dg daily a check duration