transformer test
Answers were Sorted based on User's Feedback
Answer / mahesh bial airport
Transformer testing is mainly two type because calculating
the losses of transformer 1) open circuit test 2) short
circuit test. In opencircuit test showing hystorisys
loss ,eddy current loss ( magnetic loss ). In short circuit
test showing copper loss of the transformer
| Is This Answer Correct ? | 19 Yes | 0 No |
Answer / bimal
Transformer testing is mainly done to know the correctness
of wdg,core, etc.....
The Lv tests are.
Vector Group,Magnetic Balance,Magnetizing Current,Ratio,
Hv test are.
Impulse test,switching,etc.
| Is This Answer Correct ? | 9 Yes | 2 No |
Answer / venkat
Transformer test are,
Insulation Resistance Test,Voltage Ratio Test,Magnetic
balance test,Vector group Test,Magnetising Current
test,Short Circuit Test,Oil Test
| Is This Answer Correct ? | 7 Yes | 1 No |
Answer / dany
Basically transformer tests are of two types.
1)short ckttest 2)open ckt test
short ckt test gives us 1)copper losses 2)voltage regulation
3)lekage impedances(ie. resistance and lekage reactance )
open ckt test gives us 1)core losses 2)parallel component
values (ie Rc and Xm)3)secondary voltsge
Open ckt test will be done on lv side ,while short ckt test
will be on high voltage side
| Is This Answer Correct ? | 6 Yes | 4 No |
What is the Difference Between the SCADA & PLC ? Both it also control and Supervise Then what Special in Scada & PLC?
Transmission through a short line depends on
Where voltage are high and current to be interrupted is low the breaker preferred is:
there is an alternator 480 k.w, 400v,50hz, 4-wire running on load having leakage alternator body earthed current 38 A. is it within acceptable limit? if yes then give reference if no then how to bring within specified limit
in alternator permanent magnet generator is also connected on the alternator shaft,then y that PMG voltage is very low as compared to alternator?
why there is a high voltage line in multiplication of 11?i.e.- -66kv,11,kv,22kv
what is use of thermistor ?
what is creep of energy meter?
What is difference between Earthing, Ground and Neutral?
1 Answers ABB, ABC, Indo Asian,
Explain how Hormonics will effect the Electrical System?
Specify the crystal frequency required for an 8085 system to operate at 1.1MHz
why abcd parameters are called transmission parameters
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)