Answer / alok das

It is the most important and common type of fuse unit used
all day by day work in domestic in stallations.It can be
rewired, even if the cut-out terminal are energised,
without taking any safety precautions.

Answer / gurvinder singh

It is a type of rewirable fuse which has two parts. The part which carries the fuse element is known as kit and the fuse base is known as kat. The kit is fitted on kat and the circuit is ready to use

Answer / simon

The most common type of rewire able fuse use according to use (15 Amp MAX).It has 2 parts namely base,carrier made from
Porceline (a advanced version of china clay).

Answer / akarshit kanwar

Kit Kat fuse is a rewireable fuse .It is of two type kit and kat. The part which carries fuse element is know as kit and the part which carry the fuse base is know as kat. Kit is fit over kat

Answer / aadish rahman

It is a type of rewirable fuse. It consists of three components fuse element, fuse carrier ,fuse base

What happens if a +vely charged particle is placed in the centre of a room and assume that the north side wall is having magnetised with north polarity and south side wall is magnetised with south polarity. In which direction the particle will move

5 Answers   BSNL,

i want design of D.C.MOTOR 1HP 960RPM AND 2HP 960RPM ITS URRGENT

0 Answers  

why EMF IS INDUCED IN A CONDUCTOR WHEN FLUX LINKING WITH IT CHANGES ACCORDING TO FARADAYS LAW.

0 Answers   Sail,

What is difference between insulating medium and fault current interruption medium in a switching device.

0 Answers  

For a CT the number of turns in the primary winding is.........

5 Answers  

What is mean by sink and source in term of PLC and drives,where and how they used in logic

2 Answers  

On wat basis TSM & PSM are set? Example.TSM=30% n PSM=2.5A....Hw they are set and how we come to know that the particular relay should be set to this value only?

2 Answers  

what will happen if 11KV is given to 1.5 square mm cable connected with constant load of 10A ?what will be the condition of cable after injecting the voltage?

1 Answers  

why we step up voltage for reducing the loss, even if voltage and current are proportional anr resistance remains same

12 Answers   Sarhad University,

Why is it preferred to use a wattmeter(s) to measure power in three phase systems rather than using a combination of other instruments e.g. voltmeters, ammeters etc?

2 Answers  

Is 3C x 2.5 Sqmm Cable can withstand 40Amp Starting current? If Yes then specify your ans.

2 Answers   NTPC,

What is speed mode?

0 Answers