Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / dany
Basically transformer tests are of two types.
1)short ckttest 2)open ckt test
short ckt test gives us 1)copper losses 2)voltage regulation
3)lekage impedances(ie. resistance and lekage reactance )
open ckt test gives us 1)core losses 2)parallel component
values (ie Rc and Xm)3)secondary voltsge
Open ckt test will be done on lv side ,while short ckt test
will be on high voltage side
| Is This Answer Correct ? | 6 Yes | 4 No |
Post New Answer View All Answers
what is the effect of vector group while phase sequence of a generator changes,whether the vector group changes or not
Is there any specialised book to refer about fault level calculation both in MV and LV side??
how to caculate cable size for diff types of loads? if anyone know the calculating procedure please tell me
what parameters are should nessary for control technic dc drive(in rolling mills)?
how to meas-our losses for L.T & H.T
What is the difference between electronic regulator and ordinary rheostat regulator for fans?
Diagram and details of polarity test for Current Transformer 11kv 400/200/100/1A
What is ramp signal?
How to determine the breaking capacity such as break down current and break down voltage for VCB and CT's.
An ISP is granted a block of addresses starting with 150.80.0.0/16. The ISP wants to distribute these blocks to 2600 customers as follows. a) 200 medium size businesses; each needs 16 addresses b) 400 small businesses; each needs 8 addresses c) 2000 households; each needs 4 addresses Design the subblocks and give the slash notation for each subblock. Find out how many addresses are still available after these allocations.
How we can come to know the substation range,without go through any name plate ?
What is the de rating factor of cable? What is the importance of the de rating factor in cable select
why does connected a indutor with mnsformeretering core of current transformer ?
How to calculate no of EARTH PIT? Describe the formula as per IS standard?
1. The DC generaror,s induced output emf is connected with a DC motor(as load). when increasing the load of the motor by using brake drum or any way. what are the parameters will changes in both motor and generator(voltage, current, resistance, frequency, speed, torque, power, flux etc...) 2. Similarly for AC generator and AC motor 3. similarly if using DC batteries instead of DC generator, What happens?
