Answer / amol deshmukh

RSLogix 500 classic,RSLogix 500 emulator & Rslinx

Answer / nagaraju

rslinx
rslogix 5000
rslogix 500
control net

Answer / kunal

RS Logixs 3.5A

Answer / oarhe ize

Ladder logic.

Answer / balakrishnan

micro logic

Answer / pitchaikannu

control net

I have a question, I visit 01 site and face a problem, there is 2.5 ton Air Con working, when air con compressor is running at that time rectifier voltages are increasing upto 290-295 v and rectifier is giving main high alarm (rectifier is APC single phase), before starting compressor rectifier voltages was 230v. when air con is going off rectifier voltages are decreasing smoothly at its actual voltages 230v. Load on Genset phases is this: Red-13.5 amp AC (Air Con load), Yellow-1.7 amp AC (BTS lights etc.) and Blew-4 amp AC (telecom system load), Genset phase to phase and neutral to phase voltages are also ok. These are 10 sites having same system and same rectifier APC brand at every site 02 genset are working but the problem is same at all these 10 sites. What will be the reason behind???

1 Answers  

What are the causes of electrical faults?

1 Answers  

What is the current carrying capacity of 0SWG,3SWG,10 & 12 SWG solid bare overhead copper conductors?

0 Answers   HAL,

Can the same motor be operated in both direction ?

12 Answers  

How big (size) can the tertiary winding be in transformer? Can we load the tertiary winding, if yes then how much we can load it?

1 Answers  

How can we calculate the motor frame sizes?

0 Answers   Essar,

WHY EARTHING NOT NEEDED IN BATTERY IN SUBSTATION

0 Answers  

what are different types of electrical windings? i know the distributed winding ,concentrated winding etc but i want some detailed information, in what condition we will use distributed,concentrated windings what are the difference between them which is best, how induced emf changes by using different types of windings 20 hours ago - 1 week left to answer

0 Answers  

What is the importance of RESONANCE

2 Answers  

the distance from my office to d.g is aprox 400mtrs and voltage drops ibn my office near about 40 volt what should i do p[ls suggest.

6 Answers  

ACCORDING TO IEC WHAT SHOULD BE THE MINIMUM HEIGHT OF G.I. STRUCTURE OF CT, PT, ISOLATOR, LA?

0 Answers  

I've descovered that when the earth wire in a domestic electrical installation is not connected back to the board (ground) a voltage of between 9-24v is is found to be present in the earth wire. When connected at the board there is no voltage - is this normal and why does it happen?

3 Answers