I have a question, I visit 01 site and face a problem, there is 2.5 ton Air Co

I have a question, I visit 01 site and face a problem,
there is 2.5 ton Air Con working, when air con compressor
is running at that time rectifier voltages are increasing
upto 290-295 v and rectifier is giving main high alarm
(rectifier is APC single phase), before starting compressor
rectifier voltages was 230v. when air con is going off
rectifier voltages are decreasing smoothly at its actual
voltages 230v.

Load on Genset phases is this: Red-13.5 amp AC (Air Con
load), Yellow-1.7 amp AC (BTS lights etc.) and Blew-4 amp
AC (telecom system load),
Genset phase to phase and neutral to phase voltages are
also ok.

These are 10 sites having same system and same rectifier
APC brand at every site 02 genset are working but the
problem is same at all these 10 sites.

What will be the reason behind???

Question Posted / wap

1 Answers
3131 Views
I also Faced
E-Mail Answers

I have a question, I visit 01 site and face a problem, there is 2.5 ton Air Con working, when air ..

Answer / k.prakashchandra

Interchange the loads on the 3 phases

Is This Answer Correct ?

1 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

In a generator (Synchronous) does the rotor speed (frequency) corresponds to the speed of the water (in hydro). does the torque on the turbine relate to the flow of water?

2 Answers

what is tertiary winding in transformer?What is its purpose?

18 Answers Bhel,

why transformer are not used in D.C SUPPLY

5 Answers

i have gear oil pump with single phase motor.some time its motor starts running in reverse direction rather than forward direction...whats the reason behind this issue. 1- either capacitor is week? 2- or winding is week?

0 Answers

what is the formulae for calculating the cable size for a given voltage and current.

4 Answers Bharat Forge,

11 KV distribution system where neutral is produced ?

4 Answers ciss, TATA, Tata Motors,

The neutral&earth voltage is 0v.But we were connected the lighting load at the time ballast was failed.why?

1 Answers

cost of operation of which plant is least?

6 Answers

Difference between PLC and SCADA ? What are merits & De-merits of PLCs ? What are merits & De-merits of SCADAs ?

3 Answers Ambuja,

Define what is difference between fuse and breaker?

0 Answers

What are the different modes of plc processor?

1 Answers

how to calculate diesel consumption of diesel generator by considering load and capacity of generator?

1 Answers

For more Electrical Engineering Interview Questions Click Here