Answer / prashant

50HZ is the standard our system has decided, so why you want
to disturb the system?? Your source with about 2% above and
lower than standard freq. can not be synchronized wit the
system.

Answer / anil kukarni

we r not able to genrate more then 50Hz.

In VSD (variable speed drive)I/P and O/P connections given wrongly what will happen?

5 Answers  

---

how can we test the polarity of a 3-phase transformer?

2 Answers  

---

how we control automatic generator i'e with to supply (main supply and local generator) when the main supply was break to supply the local supply automatically to begin supplying power.I now this control circuit is the combination of contactor time delay contactor switch and overload relay .but my question is how we combine those component thank you

0 Answers  

---

how to store the thunder power?

1 Answers   Voltech,

---

Why 268hp induction motor taking different current in three different phases? (In which two phase having same current and one having higher value compare to other 2 phases.)

1 Answers  

---

What is the meaning of maximum demand

21 Answers   MN Dastur,

---

what is skin effect?

4 Answers  

---

Main Differance between Primary Distribution & Secondary Distribution Of Electricity....?

1 Answers  

---

Is it possible to measure correct value of earth resistance & cable insulation ristance with out disconncting earth lead & both sides of cable ends? If not, any other method to measure ER & CIR with out disconneting from the system.

0 Answers   HAL,

---

why and where we use early make & late break contacts in protection?

0 Answers  

---

why ct is connected at bushing of transformer ??????????

3 Answers  

---

how we decide wire gauge for ac or dc coil and what is the basic diff. B/w these two coil?

0 Answers  

---