What is the difference between voltage transformer and
potential transformer?
Answers were Sorted based on User's Feedback
Answer / the pm
voltage transformer is generally used to step down the
voltage but potential transformer is used for both step
down the voltage as well as for protection basis.
| Is This Answer Correct ? | 7 Yes | 14 No |
Answer / nilesh kasar mumbai
VOLTAGE TRANFORMER STEPS UP/DOWN VTG BUT PT ONLY SENSES VTG
| Is This Answer Correct ? | 1 Yes | 10 No |
Answer / maharaja.a
THE VOLTAGE TRANSFORMER USED ONLY BELOW 110 KV PROTECTION
BUT THE POTENTIAL TRANSFORMER USED FOR HIGHER VOLTAGES.
| Is This Answer Correct ? | 1 Yes | 10 No |
Answer / vishal shirke
potential transformer is used to measure voltage difference
between any two points.voltage transformer is used to
measure line voltage.
| Is This Answer Correct ? | 1 Yes | 18 No |
Answer / sareer ahmad lone
Basically,both these transformers perform the same
function.That is for metering and protection.
| Is This Answer Correct ? | 32 Yes | 50 No |
Answer / nilesh shinde
as per construction both are same but potential transformer
is always step down type transformer where as power
transformer may be step up or step down type.
| Is This Answer Correct ? | 26 Yes | 63 No |
Answer / a.ragavendran
current transformer is a step up transformer,the primary of
this transformer consists of a large no.of thick wire
connected in series with line. In case of P.T is a step
down transformer,the primary of this transformer consists
of a large no.of fine wire connected across the line.
| Is This Answer Correct ? | 16 Yes | 68 No |
What is metering cubical? What is the use?
How would you supply a single house hold load from a 3-phase supply coming out of a sub-station?
Saving in copper achieved by converting a 2 winding transformer in to an auto transformer is determined by A voltage transformation ratio B load on secondary C quality of core material D size of transformer core
how to calculate the knee point voltage of current transformer?
What are the components of a substation?
armature is that part in which current is induced since in dc motor we supply current to the conductor so why we call it armature?
What is the name and type of power transformer oil?
send me all basic electrical question and answers
why we commonly use delta star winding in power and distribution transformers
What are the types of TESTS in CIRCUIT BREAKERS based on Testing and commissioning?
sir i am pradeep singh from electrical branch and i want to place in software industry(tcs)but i dont know much about programmig languages like c c++.so how can i get a placement in software industry?
Tan delta point in transformer to be earth or not?
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)