Answer / bharti

dont woory ...u can gt job in
TCS as well as other s/w companies also...they will give you
initial trng. so dont worry abt that.

What are the various methods for effecive earthing in a factory in a rocky terrain, where soil resistivity is extraordinarily high? The usual method of 3 m deep earth pits is not serving the purpose.

4 Answers  

---

Define reserve-generating capacity?

0 Answers  

---

What is pd controller?

0 Answers  

---

what is O.T?specify the acceptable range?

2 Answers  

---

what work will do diffrential realay DG set

0 Answers   IG Petrochemicals Ltd,

---

oil sample dielectric test gives the insulation rupture voltage at 26 kv. is this transformer safe to be operated . The working voltage is 11 kv

2 Answers  

---

what is working of no & nc.

8 Answers  

---

I have a question, I visit 01 site and face a problem, there is 2.5 ton Air Con working, when air con compressor is running at that time rectifier voltages are increasing upto 290-295 v and rectifier is giving main high alarm (rectifier is APC single phase), before starting compressor rectifier voltages was 230v. when air con is going off rectifier voltages are decreasing smoothly at its actual voltages 230v. Load on Genset phases is this: Red-13.5 amp AC (Air Con load), Yellow-1.7 amp AC (BTS lights etc.) and Blew-4 amp AC (telecom system load), Genset phase to phase and neutral to phase voltages are also ok. These are 10 sites having same system and same rectifier APC brand at every site 02 genset are working but the problem is same at all these 10 sites. What will be the reason behind???

1 Answers  

---

what is the procedure for cable sizing or on what basis we will calculate the size of cable?????

6 Answers   ANG, Focus, Mecon,

---

Is it possible to connect a safety device in to parallel?

0 Answers   Jones Lang LaSalle,

---

Why Indian Electricity frequency desined 50 Cycles as developed countrys are using high frequency with low voltage

1 Answers  

---

in basic 2 phase will short means tripping the power but spot welding 2 phase shorting but not tripping it will welded why.....(Q)

0 Answers  

---