why 4-20 mA signal is preferred over a 0-10V signal

17 Answers   Sofcon,

---

Where are oxygen analysers installed in cfbc boilers? What are their usual readings?

0 Answers  

---

why we use impulse line of flow transmitter at 45 deg. angle both side of orifice plate.

0 Answers  

---

how to check earthing,what is minum ohms for proper earthing

0 Answers  

---

Paper Details: company -- Hindustan Copper Limited post -- GET 2008 Date -- 03.08.2008 Dept.-- Electronics?Instrumentation Aptitude -- 70 Technical-- 80 Total Time -- 2hr 30min I have listed the question I could able to remember 1. BCD equivalent of 43 2. value of K for stability of a system from a given equation 3. transformer connection for darlington connection 4. damping of balastic galvanometer 5. advantage of chart-pen recorder over CRo 6. CRO - how to change bandwidth 7. questions on CRO construction 8. reverse saturation current of si diode 9. advantage of wire wound resistance over carbon resistance 10. core material for a small coil 11. max fanout-- TTL/ECL/CMOS/MOS 12. component of resistance of monolithic IC 13. functions of capacitors in multivibrators 14. to change a sawtooth signal into a square wave we use-- schmit trigger/ schottkey diode/ zener diode 15. relation b/w á & â in transistor ckt 16. function of SiO2 layer in fabrication 17. 3 questions on ODD MAN OUT

2 Answers   HCL, L&T,

---

generally transmitter power supply having some range(12v to 35v) but the out put(4-20 mA) must same for given input.If we vary the power supply voltage then output mA also to be change according to V=IR. Is there any voltage regulator in the transmitter ?

1 Answers  

---

what is the role of proportional in process control?

6 Answers   OGDCL, Trident,

---

how many types of preheaters are in cement industry & what r they can any body explain?

0 Answers  

---

i want the equation of this question. Tranmitter range is 120 mmwc and dcs flow range is 1700 nm3/hr. if i want to change dcs range from 1700 to 2400 nm3/hr then how much dp i have to enter in transmitter

2 Answers   GMR,

---

What is mean by Ethernet, Device net and Control net? For what application we are using these?

4 Answers  

---

Can we used Condensate Pot on flow transmitter which is using on liquid having sluge and DP transmitter is in pit and below the process line,Can we used Condensate pot for accamulate the Sluge?

1 Answers  

---

what is a device net.

1 Answers  

---