Paper Details: company -- Hindustan Copper Limited
post -- GET 2008
Date -- 03.08.2008
Dept.-- Electronics?Instrumentation
Aptitude -- 70
Technical-- 80
Total Time -- 2hr 30min
I have listed the question I could able to remember
1. BCD equivalent of 43
2. value of K for stability of a system from a given equation
3. transformer connection for darlington connection
4. damping of balastic galvanometer
5. advantage of chart-pen recorder over CRo
6. CRO - how to change bandwidth
7. questions on CRO construction
8. reverse saturation current of si diode
9. advantage of wire wound resistance over carbon resistance
10. core material for a small coil
11. max fanout-- TTL/ECL/CMOS/MOS
12. component of resistance of monolithic IC
13. functions of capacitors in multivibrators
14. to change a sawtooth signal into a square wave we use--
schmit trigger/ schottkey diode/ zener diode
15. relation b/w á & â in transistor ckt
16. function of SiO2 layer in fabrication
17. 3 questions on ODD MAN OUT
Answers were Sorted based on User's Feedback
Answer / babu
1. 0100 0011
2.From Routh array it can be calculated.
| Is This Answer Correct ? | 1 Yes | 1 No |
pls provide me syllabus and old question paper of instrumentation engineering for GET(JSPL)
i want to Measure the Difference pressure of Packed distillation Column of height 3 mtr. h.p. side connected to bottom & L.P. side connected to the top , so tell me what will be THE URV & LRV of that D.P. transmitter?
how to measure low temperature(<100 dec celsisus) with non condact sensor
why the steam drum and deaerator level transmitter range is in negative MMWC to zero
3 Answers Emerson, Jindal, JKPM,
what is the input of digital counter during the the calibration time?
How to set up the various advanced process controllers, input the proper parameters, and tune those controllers given related control system information.
what is pressure control
1 Answers GNFC, IBM, Privi Organics,
what is function of ESD , and how is it work, explain with difination
1 Answers Bapco Bahrain Petroleum Company, BMB,
how can i calibrate the temperatuture gauge used by temperature bath(dry block) i mean step by step procedure?
What is the detail function of I/O card in DCS ? Why we dont use the I/O directly with controller?
how to wire from pressure transmitter to marshalling panel and panel to controller and controller to dcs plz give the answer with example .
Which wiring connection is preferred in motor for industrial use?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)