Answer / carl_ellis

Yes, you can use a condensate pot to accumulate the sludge.
It's just a version of a "drip leg" that extends down
vertically below the tap or port for the impulse line (at
the datum elevation) to the DP transmitter. Other methods
are just constructing a drip leg from pipe fittings that are
rated for the temperature and pressure.

A consideration is whether the drip leg or pot can be
drained to remove the sludge, because it will fill up over time.

Carl Ellis
Measure First

What is the difference between working pressure and calibration pressure of a control valve

0 Answers  

---

how to calibrate any tansmiter by loop or hart calibrator

2 Answers  

---

Why is the length of cable layyed from RTD to temp. Transmitter should be minimum? Why does heating effect takes place in their?

1 Answers   Process Control Technologies,

---

what is the meaning of GK value(fullform) in flowmeter ?

3 Answers   Essar,

---

DC motor and DC Drives working funda?

1 Answers  

---

when we are using HART COMMUNICATOR why we are using 250 ohm resistance while using HART COMMUNICATOR.

7 Answers  

---

what is commisioning procedure,2)what is is the main work in commisioning in the field tx to dcs, plz send me detail

0 Answers  

---

If we increase PI controller what will be action.

1 Answers   IMECO,

---

what is working principle of presure and temperature guage?

4 Answers  

---

what is Mv with respect to temprature in thermocouple

2 Answers  

---

In which principles tx ,pressure gauge,Temp gauge,control valve works?

0 Answers   Bajaj, Professional Instruments,

---

Dear Sir/Madam,im going to attend Hpcl written exams on feb 17th in instrumentation stream..can anyone send me the HPCL model papers and pattern of HPCL ....i ve not yet attended anything in HPCL...so i dont know how it comes...so just i need some model test papers and pattern ..pls help me friends...

0 Answers  

---