Answer / menaka

electrical consists of ac current and electronics controlls
dc voltage

Answer / gopinath.d

electrical deals with the analog values.
electonic deals with the digital values either 0 or 1.
electronics is the application of electrical

Answer / thanigai1984

ITs really good question:

In electrical We used fixed frequency Like 50HZ..60HZ(USA)
In electronics its variable frequency ..we used any
frequency as you want

Answer / khanzada cecosian

a short answer is that electrical deal with conductor and
elctronics deal with semiconductop

Answer / ss meena

study of current at high dc power is called electrical and
study of cuurent at low ac power is called electronincs

Answer / jeevan verma

ELECTRICAL IS BRANCH WHICH DEALS WITH POWER
TRANSMISSION,DISTRIBUTION AND IT WORK AT LOW FREQUENCY
ELECTRONICS IS BASICALLY DEALS AT MICRA TO NANO LEVEL AND
ALL THE INSTRUMENT WHICH WORK AT 10 TO 20 VOLT COME UNDER
ELECTRONICS WHEREAS ELECTRICAL WORK AT MUCH HIGH VOLTAGE LEVEL

Answer / pragya

electronics appliances operate below 25 volt.

electrical appliances operate above 25 volt.

Answer / sabeel vazhakkad

Electronics is the branch of science which deals with the study of flow of electrons through a semiconductor or vacuum tube.
but Electrical is the study of flow of electrons through conductors....

in Electronics flow of current is controlled by current or voltage, but in electrical its controlled by resistance..

Answer / pranay patakha

electrical is an energy which gives effect
electronics is a branch of engineering in which we study
about semiconductor

Answer / kamran khan

in electrical circuit we use conductors and in electronic
we use samiconductors.

How to calculate HV Cable Sizing & what are the factors to be considered for selection?.

2 Answers  

how to improve IR value in HT motors?

3 Answers   ABB, AMW, Macleods,

Can we use Motor protection CB while we use the VFD for Speed control?? if not means please tell the reason!!!

1 Answers  

why does a dc machine has high efficiency while working as a generator than as a motor ..

0 Answers  

what happened if power factor is "1"

9 Answers   Reliance,

how the alternator transfere mechanical energy to electrical one ??

3 Answers  

In my power station 220 volts dc battery set. they coneected 84th cell taped

1 Answers   KPTCL,

is the secondary voltage of current transformer greater than primary voltage,,,,,,,,] give the example with ct burden,current ratio,and primary and secondary side voltage?

2 Answers  

what is the diffrence between capasitor and battery?

2 Answers  

is there any device that works properly accept relay, it may be fuse but if i want fuse of 33kv 300 amp it is avaliable, pls give me details

0 Answers  

if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.

0 Answers  

How Negative Phase Sequence Relay works in case of Synchronous Motor?

4 Answers   L&T,