Answer / ravi

electrical system always deals with low frequecny high
power supply

electronic system always deals with high frequecny low
power supply

Answer / k.senthil kumar

The study of conductors is Electrical
The study of semicoductors is Electonics

Answer / senthil kumar.a

hi

the current flows through the conductor that is known as
the electrical.

The current flow through the vaccum tube or semiconductor
that is known as electronics. now a days we r not use the
vaccum tube.

Answer / vijaymuthu

eletrical is transfor a.c current-electronics is control
circuit in d.c voltage

eletrical use fundamental all purpose--eletronics use based
on eletrical

Answer / subodh kumar

electronics deals with volatge from 5 to 12 V and current
in mili amperes where as electrical deals with in large
voltages and current.

Answer / ritesh gupta

electrical deals with high voltage & high current.
but electronics deals with low voltage & low current.
electronics used for controlling purpose of electrical quantity

Answer / ravi kumar

electrical means of high voltages
electronics means of low voltages

Answer / rajasekaran

Electrical is a science of engineering deals with
Generation,Transmision&Distribution of electrical enery.And
also dals with how to convert electrical energy into useful
work means electricalmachines like motor,lightings.


Electronics deals with flow of electric charges in
semiconductors and effects in it.

Answer / madhu

'Electical'- utilises electricity to transmit energy.
'Electronics'-utilises electicity to transmit information.

Answer / athar

1.electrical basically deals with power and energy
transmission while electronics pertains to study and
development of devices which are based on flow of electrons
through devices
2. electrical pertains to transfer of energy through
electricity while electronics transfers information through
electricity
3.electrical works on low frequency high power while
electronics on high frequency low power.....

sir,in our plant we r using SATEC PM172E power reading meeters in HT panel side it is monitoring the MB data smart viewer(sever).but last one week we did not get readings inthe server only available in meeter.tell me how communicate meter and server. and also what steps we take for checking.

0 Answers  

i asked a funny question in Electrical ohms law V=IR in const temp voltage is directly proportional to current Power p=VI cos@ in that formula Voltage is indirectly proportional to current Try to give me the fact what is happening in Electrical.. contact Thanigai_1984@yahoo.co.in

3 Answers  

What is the temperature and cooling aspects of dc motor

1 Answers  

Does RCCB do the job of MCB? Lets take 16A RCCB. it trips when residual current exceeds 30mA. does it trip in an over current situation, i.e when current exceeds 16A ??

2 Answers  

How to run 1ph motor(230 VOLTS its full load amps is 4.5 ampa))with 480 volts main(we didn hav neutral)Thn we go for step down transformer.Our load 10 amps,so we conisder this amps in primary are secondary side

1 Answers  

what is the necessary of using inductance property in transmission lines even through resistance is used to opposes the high current flows in that?????

0 Answers  

Why is voltage is required to be within permissible range for an electrical equipment?

0 Answers  

HOW COULD A SINGLE PHASE INDUCTION MOTOR ROTATE IN OPPOSITE DIRECTION???

3 Answers  

What is different between Circuit breaker and Isolater?

0 Answers  

I want to do a mini project. Now I'm studying in 6th semis tor EEE Engineering.

0 Answers  

How to calcute the cable size for both HT and LT please specify the formula for that Regards Chethan C

1 Answers   Bhel, Student,

what is the different between DC & AC load Line.

1 Answers   Emarat,