for 100 HP Induction motor service factor is 1.2(SF) we placed a VFD at the moto

for 100 HP Induction motor service factor is 1.2(SF) we placed a VFD at the motor side load is balance with 0.3 Amp's Phase to Phase but at incoming of VFD load is un-balance with 10 to 20 Amp's what will be cause of load un balance

Question Posted / jithendra

0 Answers
1951 Views
I also Faced
E-Mail Answers

No Answer is Posted For this Question
Be the First to Post Answer

Post New Answer

More Electrical Engineering Interview Questions

What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?

0 Answers

how much current does 3ph. 10 hp ac motor draw.

8 Answers

Why the steam turbines are run at high speed where as the hydro turbines are run at low speed?

1 Answers

what is strip power factor?

0 Answers TATA,

what do you mean by lagging and leading current.explain in detail.

1 Answers

how we can calculate cable size of 230v,1 hp single phase motor ? panel to motor distance is 25 meter

4 Answers

If carbon brushes spring tension either loose or tight, what happen on Motor performance During Full load Operation?

5 Answers Electrex, HP, TATA,

HOW DO I CALCULATE OVER LOAD RELAY & CONTACTOR IN DOL STARTER? & in dol why it is require circuit breaker?

6 Answers DLF,

which connection is safer series or parallel?usually which connection we prefer at home?

5 Answers

Hello sir This is prakash from bangalore i have a doubt why we have to maintain DG power factor in the range 0.78 to 0.8 Perhaps i f it is increased means what will happen in DG

3 Answers

why we are used thermistor in motor

1 Answers

How Humming noise generated in starter motor which was used the start the engine in a vehicle/car/Truck?.Moreover Starter motor was operated in DC power supply. Can you guys clarify ?

2 Answers

For more Electrical Engineering Interview Questions Click Here