When we need up only in o/p 440v, so why we use directly in 11kva in input?
No Answer is Posted For this Question
Be the First to Post Answer
IN a transformer during power supply how the LV and HV bushing works??
Following test should be conducted to find out relative polarity of transformenr terminals A no load test B back to back test C phasing out test D none of above
what is mean by amf
I have been short listed for sydicate clerkcal post .i have interview on 15th sept..i want to ask if i don't know kannada to read and write they won't allow me to attend the interview?Do send u r reply.......
When a square wave is applied to primary of a transformer then what will be output wave form of secondary ?
what is basic difference betmeen normal & flame proof motor??
why the impedence of the transformer is expressed in percentage?
why in large rating C.T.s equipotential wires are used?
Two electrically operated Vibro Motors are fixed in parallel direction in vibrating feeder. What is the direction of both Vibro Motors?
What is the HVDC Transmission System? What are the conditions applicable to lay an HVDC Line?
Can you tell me more about pu systems (per unit systems )calculation in large power systems? how to get the base for voltage and power in generator, transformator and transmission lines?
why we provided electrical earthing?
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)