Answer / hussaini

Bushings is just used to give
proper insulation to the
income and out going wires
of transformer ..

Answer / surya

stepdon transformer and stepup transformer Lv and Hv busing working

Answer / k.prakashchandra

They are only the conductors

What is the meaning of ST and HT in electrical transmission and what are thier range.

6 Answers  

---

two generator runnig with parallel but only one NGR on And one off Why

1 Answers  

---

Capacitor panel CT is normally fixed on Y phase of the main panel.why???

3 Answers  

---

i have ht transformer of 142 kva with air cooled facility,having secondary voltage 7850volt, and secondary connected full way bridge rectifier .i faced the problem repeatedly that transformer one coil and rectifier diode of two phase was burnt two times. i checked all the secondary ckt. no any short ckt found,then what will be the cause side

2 Answers   Modern Terry Towels,

---

what is the difference between potential Transformers and capacitive voltage transfoemers and where it is used?

5 Answers  

---

How much current flow in no load condition of a motor?

8 Answers  

---

If there are two transformer having rating of 2.5mva, 6.6kv/440v(satr-star),and the load is 600kw then what is better to maintain less losses in transformer having both transformer in parellel or only single transformer connected to load? Please give calculated answer

0 Answers   UltraTech,

---

What will be the current drawn by HT motor, if low voltage is applied.. any formula to calculate the LT amps of HT motor.?

0 Answers  

---

How can we calculate strength of copper hich is supplying electric power to heater and in it hold the heater also and what r all types of forces which is acting on it...

0 Answers   ABB,

---

Reduction in supply voltage by 10% will change the torque of the motor by ___.

1 Answers   UGVCL Uttar Gujarat Vij Company Ltd,

---

What is the maximum and minimum rating of UPS?

0 Answers   Indiabulls,

---

is ac supply can store

0 Answers  

---