why we provided electrical earthing?
Answers were Sorted based on User's Feedback
Answer / joy
this makes low resistance path for current flow.so that
when a heavy current accur due to lightining or etc etc..
the current chooses the low resistance path to flow..so
that the home appliances will not get affected.. even human
too...:)
| Is This Answer Correct ? | 15 Yes | 0 No |
Answer / mahesh ch
for equipment and operator safety from shocks......
| Is This Answer Correct ? | 12 Yes | 1 No |
Answer / arunkumar
Current always choose low resistance path. when we r connect
all electrical equipment with earth it will provide zero
resistance path.So if any fault current occur it will bypass
through the low resist path.
| Is This Answer Correct ? | 3 Yes | 2 No |
Answer / tamilarasu
We are used all electrical equipments with earthing.incase
the equipment go to fault condition that time current flow
to the low resistance part. we concider the equipment body
is low resistance part so current flow to the equipment
body that time we tuch the body.the human is the concider
of neutral body is phase then phase& neutral to be short
then fuse go to burn out then human is safty from the shock
| Is This Answer Correct ? | 2 Yes | 1 No |
Answer / manikumar
for bypassing the lightning and surges.
for facilitating safety to personal and equipment from
electric shock
for discharging the induced voltages while doing
maintenance work on line
| Is This Answer Correct ? | 1 Yes | 1 No |
what collector is used for 100kmph-120kmph tracion application?
2 Diesel Generators 900KVA connected to the bus bar for essential load as an alternative for power taken from 11/440V 3KVA Transformer supplying this bus bar. my question here is in the event of power failure on 11KV side can I feed the power to 11 KV bus by using the same transformer as reverse feed, what will be the inrush current???
difference between over current and over load protection?
state the working principle of incondenscent tube?
In the Load Test of 3 Phase Squirrel Cage Induction Motor, 2 wattmeters are used. One of the wattmeter deflects in negative diretion during no load. Why?
what is meant by AYFY Cable?
what is the formulae for selcting capacitor bank to increas pf
Why the ceiling fan rotates in clockwise direction and table fan rotates in anticlockwise direction.
3 Answers Kirloskar, MPF, Wipro,
how will i find Transformer rating if supply voltage is 11k.v and how will i find incomer if transformer rating is 12MVA
The unit of electrical charge is the
Why transformer used in UPS??
Why insulation level follows this order? transformer < bus bar < circuit breaker & Isolator < transmission line.
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)