Answer / k.prakashchandra

You can measure after the metering . Do not use service wire
or meter terminal

Answer / harshid

Is there any method for voltage measurment for continuosly monitoring on neutral to earth voltage...?
I want to check quality of earthing by measuring this voltage.
If any other idea you have...
Other than earthing reaistance.
Beacause my resistance m/s depend on how electricity board earth ther syatem
Means solid earthing or etc....

Why is the starting current high in a DC motor?

2 Answers  

---

what is inter connected dc generator?

0 Answers   Lovely Professional University,

---

dear sir, i completed diploma in electrical in 2005, how i can get electrical supervisor liance in mumbai

0 Answers  

---

How to calculate Busbar Thickness for Different type of HT/LT panels

1 Answers  

---

what is power factor ?

3 Answers  

---

what is slip ring induction motor? How it works?

1 Answers  

---

I would like to know that the fault curretn at base load and at 10% generation will be same? Fault level of BUS remain same with different generation?

0 Answers  

---

how to calculate the mf of kwh meter,if ct the ratio on meter is 100/5A

2 Answers  

---

if the transformer at full load have a iron loss =900w and copper loss = 1600w . what percent of the load will the transformer has a maximum efficiency?

3 Answers  

---

what is the minimum voltage require to injure our body?

4 Answers  

---

c. int m = 10; main() { int m = 20; {int m = 30;} printf("%d %d",m,::m); 1. 10 10 2. 10 20 3. 20 10 4. 20 30 5. 30 20 6. None

2 Answers  

---

whenever any squirrel or a crow falls on the transformer input line then there is a big explosion and 440 volts of power is being discharged through the neutral line due to which appliances in off mode are also burned.we have earthing for the transformer as well as the bus bar chamber.why is it happening?

1 Answers  

---