Interested to Buy Any Domain ? << Click Here >> for more details...
i want to measure voltage difference between neutral and
earth so i just simply use voltmeter.
my question is that may i use this measure continuosly.or
there are some electricity board restrication on that? or it
creat some problem on my measuring device..?
- 2 Answers
- 4380 Views
- NEEC, I also Faced
- E-Mail Answers
Answer Posted / harshid
Is there any method for voltage measurment for continuosly monitoring on neutral to earth voltage...?
I want to check quality of earthing by measuring this voltage.
If any other idea you have...
Other than earthing reaistance.
Beacause my resistance m/s depend on how electricity board earth ther syatem
Means solid earthing or etc....
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
I have c license but I don't know eligibility of Max Kilo Volts under the electrical licensing board.
what is the formula to calculate voltage drop/loss on 66KV Transmission Line?
Which type of DG need Netral Earthing?
define as synchronous generator
why the earth is taken minimum in supplying? wather it the proportional factor to getting work any equipment or a power plant?
What is cut-off rate?
How to Make relay co ordination chart for a Electrical power distribution of a plant
with 3 phase board on a 63 amp rcd is it ok to have 6 electrical showers 2 on each phase and what problems could happen
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
what are the tests comes under the type test, what tests comes under routine tests.
what is the use of surge suppresser in 33 KV incoming panel. where it must be installed,inseries with incoming cable surge suppresser must be at incoming of the breaker are outgoing of the breaker
how many current required for hypo test
What is the formula for calculating the Instantaneous Short Circuit & overcurrent for any breaker
What is the numerical quantity of sqcm?
Usage of flywheel diode in relays
