Answer / kk

It depends on the application where we use the same.
MCCB have adjustable tripping characteristics where MCB have fixed tripping characteristics.
MCCB is selected if it is incommer ,MCB is enough if it is O/g feeder

Answer / aditya shirbavikar

MCB is a gear where MCCB is a switchgear. MCCB may be said to be best if chose because, with an MCCB you get a current sensing relay for auto tripping during a fault.

Answer / sunitkumarsonu

in this case mcb is better because mcb is much cheaper than the mccb.

Answer / revanna

mcb is much enough becase load capacity is too low
so,insted of MCCB is better to using MCB becase low cast.

Answer / seshagiri204

MCB is Simply a Mechanical Switch which makes or breakes the circuit by hand. In other words MCCB is a current sensing device which detects the abnormality in the circuit and trips the circuit. Today many of them are using MCCB only. And further As for as fault concern it is better to select MCCB

Answer / nur.asidik

according to my experience, if load continuous current less or equal than 60A, it is better to use MCB, it is easy to install and cheaper. you can select MCB tripping class A,B or C depends on your application.

Answer / sahedul islam sagor

MCCB tripping Capacity is low when MCB. We know a machine starting current is high but its running current is normal if we used MCB it will trip instant with starting current but if we use MCCB it will take a little time for running machine.

Which of the following statements is incorrect?(a) 1N = 1 kgm/s2(b) 1V = 1 J/C(c) 30mA = 0.03A(d) 1 J = 1N/m

1 Answers  

What is the difference between UPS and SMPS?

7 Answers   Mukand, NightFox,

what is the type of starter used in tube light?

2 Answers  

If the feeder rating is 7.5 kw or 10 HP star-delta feeder, MCCB is taken as 63 a, contactors-32 a, how much will be the OLR rating or which range OLR should be considered when we concern about type-2 coordination?

0 Answers  

What happens if fuse is connected to neutral wire

9 Answers   HAL,

why aggregate is placed all around substation ground.

1 Answers  

why we test the core balance of the transformer?

1 Answers  

i need the curve duty cycle and amper for (150 kva @50% dyty cycle) transformer turn ratio :19 and vin 400

0 Answers  

how to calculate the power loss of cable?

1 Answers  

how to determine the cable size...pls explain me with the formula taking particular load....does the factors like impedance & short circuit rating influence the cable size, if so how....

0 Answers  

How is the connection of the tap changer on the HV side been made?

0 Answers  

which is best ac or dc

3 Answers