Interested to Buy Any Domain ? << Click Here >> for more details...
if you asked to choose a ckt breaker from MCB & MCCB for 32A
which one will be best and why??
- 7 Answers
- 9189 Views
- I also Faced
- E-Mail Answers
Answer Posted / revanna
mcb is much enough becase load capacity is too low
so,insted of MCCB is better to using MCB becase low cast.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
The knee point of a current transformer is normally unique and known.So why in the nameplate of a CT they put the minimum value like this Vk> 400v.
What is force on a conductor in a magnetic field ?
How PADO software increase the efficiency of power plant?
What is the basic principle of operation of alternators/dc generators?
If increased the frequency up to 1000 then what changes shows in voltage?
What is maximum power transfer theorem?
what is the condition for YnD11
What will be the size of copper cable (each for 3 phase and 1 neutral) from Service connection Kit-Kat to Panel Board (i.e. to main switch) for a 6 pole 3-phase AC induction motor of 200 H.P. capacity? Amp-255 A, Frequency:- 1450 rpm.
A 50Hz,4-pole,3-phase,star-connected synchronous motor has a synchronous reactance of 12ohmsper phase and negligible armature resistances.the excitation is such as to give an open-circuit voltage of 13.2kilovolt.the motor is connected to 115kilovolt, 50hertz supplying. what maximum load can be the motor torque,line current and power factor?
what is per unit calculation?looking for simple and strong explanation thk u
How to decide cable tray size?
y we use neutral,all r told its used to for closed path..k its a just used to closed path,in a transmission line y we put same conductor used n both phase and neutral..if we use less than phase conductor in neutral mean we ll reduce cost its right r wrong..if we use mean any problem occur in transmission line..
Define resonant peak?
how to calculate earth fault relay current and CBCT ratio
What type of a DC motor would you use for a lift?
