can we use generator(a.c) as a motor.if so how if not why.
Answers were Sorted based on User's Feedback
Answer / mrithun karthik
You can do it
1)short the rotor positive & negative poles.
2) apply rated AC voltage to the stator windings
| Is This Answer Correct ? | 2 Yes | 0 No |
Answer / simon peter
Yes but the input supply should b ac supply......
| Is This Answer Correct ? | 0 Yes | 0 No |
What is meant by power factor correction?
How will you Physically differentiate A.C and D.C motor?
I would like to install the largest KW alternator to a 200 amp aluminum bus box in my home. Is it possible to install a 250 KW 400v 251amp synchronous alternator to my home?
what is the voltage level which is used in transformer short circuit test
what are the compensations considered while designing a transmmision line.
Can I use measuring current transformers in protection purposes?
If the capacitor bank is installed in switchyard say 132/22kv then on LT side say 22kv/0.433kv is it necessary to install capacitor bank for maintaining power factor. if pf is maintained on HT side then will that be maintained on LT side as well.if not then how&why??????/ please explain...........
what is the function of step up transformer?
Can a generator runs after getting 1st stator earth fault.
In view of Electrical Engg. What is the use of SCR(Silicon control rectifier)
What is proximeter? where it is used and why?
State and define norton’s theorem?
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)