what is the voltage level which is used in transformer short circuit test
in alternator why on load terminal voltage is less than no load teprminal voltage
i HP = ?? 746 watts or 735.5 and how??
A 400KVA Transformer has 400Hz frequency.if frequency is changed to 50Hz,then what will be the new KVA rating?
what determins the amount of voltage produced by a voltaic cell?
How would you calculate power loss in a resistor?
why fuse not recomended to neutral
Why shunt Generator is not recommended to start at ON LOAD condition???
the minimum clearance b/w ceiling and plane of leaf of ceilng fan shall be ..........mm
I have a question, I visit 01 site and face a problem, there is 2.5 ton Air Con working, when air con compressor is running at that time rectifier voltages are increasing upto 290-295 v and rectifier is giving main high alarm (rectifier is APC single phase, before starting compressor rectifier voltages was 230v. when air con is going off rectifier voltages are decreasing smoothly at its actual voltages 230v. Load on Genset phases is this: Red-13.5 amp AC (Air Con load), Yellow-1.7 amp AC (BTS lights etc.) and Blew-4 amp AC (telecom system load), Genset phase to phase and neutral to phase voltages are also ok. These are 10 sites having same system and same rectifier APC brand at every site 02 genset are working but the problem is same at all these 10 sites. What will be the reason behind???
Why nutral wir used thinner than phase wire
how define the torque in ac drive. from electrical side in the drive friquency ,voltage and current three factor is there.
Dear Sir, we met a disaster with our 62.5 kva genset, after rewinding we informed by our contract engg that due to return current coming in neutral & impropper earthing this happend. But after all set up & load balance we checked & found again we have about 20 to 32 amp return current on neutral. we have 12 airconditioner + 12 mini fridge on single phase line. Pl suggest any idea to solved this problem