Answer / naresh

Null meter is
continuously monitoring
the outputs of auto &
manual modes.if any
difference comes
between two modes, null
meter should
indicatess.......

Answer / muneeb

NULL meter at balanced/0/NULL position means no difference
in output voltages of AVR & MVR (manual VR. Used for Smooth
tranfer from AVR to MVR during operation.

Answer / k.prakashchandra

To indicate that auto-tracking is on . i.e. manual channel excitation is equal to that of auto channel, in case auto fails .

Answer / jayapal

AVR PANEL NULL METER USED AS A SETTING VOLTAGE AND GENERATING VOLTAGE JUST LIKE AVERIFICATION METER

Answer / krishana

Null meter used for power factor balance.

1 TPH how many Megawatt ?

5 Answers   Pioneer Labs, PSAL,

What is Droop Control in Woodward?

3 Answers  

what is under voltage protection 27

1 Answers   CLP, NCC,

Why high pressure turbines are single flow 

3 Answers  

What is the over speed in turbine? What is critical speed?

3 Answers  

What is the the sequence/logic of burner management system in boilers. What is purging and scavenging?

2 Answers  

what is significance of canister vent in condensate extraction pump & difference between vacuume balancinf line & canister vent

3 Answers   NTPC, Tata Power,

What is surging in a centrifugal compressor ? How it occur's ? How is antisurging done ?

0 Answers   RasGas,

63.5 ohm NGR is connected with our gas engine genrator running at 500 rpm, 50 hz and synched with WAPDA at 6.3 KV bus voltages, 2500A and 25KA(1 sec). can some one give me proper calculations how it comes 63.5ohm?????

2 Answers   UET,

.What is drip and drain.

2 Answers   NPTI,

What is the use of Hydraulic Coupling in-between BFP pump & BFP Motor?

1 Answers   Lanco, XYZ,

what is the relation between the grid voltage and generator voltage how to link up generator with grid

3 Answers   NDFL,