Answer / julesh das

Hyyy....
Here your phase volt is 6.3 kV means ur ngr side volt is 6.3 kv .
The fault current is 100 amp duering abnormal condition at ngr side..
So the resistance value is as below

R=V/I
R=6.3/100
=63ohm

I think this and will help u...


Otherwise give me ur email I'd I will send u the calculation description

Answer / k.prakashchandra

Rated voltage / NGR resistance = rated current

What is MFT and when it is acted.

2 Answers   HPCL,

---

What is Droop Control in Woodward?

3 Answers  

---

What is reheater protection based on what mft will be act on RH protection

2 Answers  

---

2. what is meant by exhausthood temp?

4 Answers   Alstom, ANG, GMR,

---

What is difference between secondary Air & Tertiary Air and Their use.?

0 Answers   Bhel,

---

why airtel use + 24 volts and other operators use -48 volt

0 Answers   ABC, Airtel, INDUS, Reliance,

---

What is droop.

2 Answers   Dhampur Sugar Mills, Elaf,

---

thermal power plants in steam using inlet of turbine.inlet of turbine pressure and flow is same as boiler feedpump why not use direct to turbine?

6 Answers   IBPIL, JSW,

---

Boiler capacity is 5ton, what will be the feed water tank capacity?

11 Answers   dscl, Indiabulls, Krest, TCS,

---

how mony power plants in India

3 Answers  

---

im try to calculating seawater flow required for SW-FGD system. I need a guide, equation or method to do it, can some one help me! Thanks very much

0 Answers   Student,

---

what is need of primary water system in power plant?

1 Answers   JO, MPL,

---