Answer / randhir singh yadav

Principal of droop is to povide stable operation,
Speed droop is a governer function which reduces governer reference speed as load increase.

Answer / jerry smith

DROOP in reference to any governor control, is the amount
of allowable "sag" from the desired set point, or speed. A
generator operated by itself and islanded, would be allowed
to be operated with either droop or no droop. The only
exception is that two generating sources are not allowed to
both be at zero droop. Unless their governors are directly
communicating with each other, as in Woodward 2301A systems.

Answer / sharanjit

WHEN TWO TURBINES ARE RUNNING IN APLANT IN ISALND MODE THAN ONE IS IN DROOP MODE ANDONE IS MASTER MODE.

AS THEIR ARE GOVERNERS FOR EACH TURBINE. SO WE MAKE ONE GOVERNNER FUNCTIONING AS MASTER EHICH OPERATES AND MAINTAIN ONE TURBINE FUNCTIONING AT A DEFINE DPARAMETER ,BUT THE SECOUND DRROP MODE TURBINE WILL FOLLOW THE MASTER AND WILL FOLLOW LOAD

why prds line tapping taken from ms line as Pri SH O/L temp & pressure is sufficient to full fill our requirement of PRDS..

3 Answers   GIPCL, OEGI,

---

.What is drip and drain.

2 Answers   NPTI,

---

Why reheater is not used after IP turbine.

3 Answers   Hindalco, SEC,

---

what is turn down ratio

4 Answers  

---

What is excitation current and voltage in hydro power plant ?

1 Answers   ISS, Perfect Line,

---

Why superheated are started before I'd and rd fan?

0 Answers   BCPL,

---

what is the basic use of power plant in equipment

0 Answers   JK Diary,

---

What is surging in a centrifugal compressor ? How it occur's ? How is antisurging done ?

0 Answers   RasGas,

---

Our 8mw steam turbine (condensing cum extraction) exhaust steam temperature is high even after taken it in hogger why

1 Answers   Bombay Rayon Fashions,

---

explain how the third harmonic content of the magnetising current affects transformer design

0 Answers  

---

What should be the neutral and body grounding sysytem for grid (132 KV) parallel generators (440 volts)?

1 Answers   Rahimafrooz,

---

If a pump has "N" no .of conections in the discharge. If a connection has a heavy leakage. Then it's motor current get affected or not??

1 Answers  

---