Answer / chinmay kumar patra(npti)

In case of high pressure turbine specific volume is less so less space is required.Singe pass design is satisfactory so no need of reduce the size by double pass designing.High pressure is maintained at outlet by using 1 or 2 impulse stage at starting stage so after reheating it must be able to reach up to last stage fr high work done.So high pressure at O/L of HP turbine is needy.So single pass design.

Answer / chinmay kumar patra(npti)

In case of high pressure turbine specific volume is less so single pass design performance is satisfactory so no need to further reduce the size by double flow designing.that's why in
super critical power plant IP turbine is also single flow type.

Answer / neelima

An opposed flow high pressure-low pressure steam turbine balances thrust of the high pressure steam turbine with the thrust of the low pressure steam turbine allowing a reduction in size of thrust bearings. Higher stage reactions in both turbines may be incorporated since they are offset with the opposed flow, allowing a higher steam path efficiency. Opposed flow may be established through a cross-over pipe or utilizing a double high pressure shell.

How to calculate boiler capacity? I have 1 Autoclave, Which has to use for AAC block. Dimension for this Autoclave is - 13 Meter Length & 2.2 Meter Diameter.

0 Answers   Aevitas Pharmagro,

---

what's interlock relay ?

3 Answers   International Mega Food Park Limited, National Power Training Institute NPTI,

---

1.what is the reason for transformer and lightning arrester blast in 33kv system

1 Answers   Afghan Telecom, Integra, Sanghi,

---

why seal air fan is used and where it is used and where is suction taken from

7 Answers   Bhel, ETO,

---

what is the difference between flow and force ,draught and vaccum ,tube and pipe?

3 Answers  

---

what is the condition of transformer parallel operation ?

3 Answers   BEDL,

---

A 5A rewirable fuse blows when 9A flows.determine the fusing factor?

1 Answers   Schneider, Student, Tata Power,

---

By any way can we increase the B check hours from 300 to 500

0 Answers  

---

How to calculate air to fuel ratio in boilers

1 Answers  

---

What should be the neutral and body grounding sysytem for grid (132 KV) parallel generators (440 volts)?

1 Answers   Rahimafrooz,

---

In a thermal power plant ID Fans running with full load but boiler load is only 80 % give reason ?

9 Answers   Essar, Prumatech, Tata Power,

---

what is the meaning of SST300 V56A in SIEMENS turbine

0 Answers   Siemens,

---