why the voltage transmission is always in a multiple of 11?
e.g. 110 V, 220 V, 33 kVA, 11 kVA
Answers were Sorted based on User's Feedback
Answer / lucky dhiman
becoz the form
factor for a.c sine
wave is 1.11 so
transmission
voltage will always
bi multiple of
11. . . . . .
Is This Answer Correct ? | 2 Yes | 4 No |
Answer / ranjeet chaurasiya
It can not be given a very exact technical reason on the basis of form factor because at EHT level we see that 800kV. We can say its an arbitrary standard from starting days of transmission of electricity to make uniformity all over the country.
Is This Answer Correct ? | 2 Yes | 4 No |
Answer / anil singh
IT IS DIRECTLY RELATED TO THE FORM FACTOR.I STUDIED POWER
SYSTEM AT LONDON UNIVERSITY AND I KNOW QUITE WELL THIS
ISSUE.
Is This Answer Correct ? | 2 Yes | 4 No |
Answer / sushendu ghosh
This is due to the design of core of transformer.The core is
selected in a standard manner by using standard tabular formula.
Is This Answer Correct ? | 4 Yes | 7 No |
Answer / d.k.gupta
Because transformer ratio,voltage is directly proportional
to number of turns.
Is This Answer Correct ? | 8 Yes | 20 No |
Answer / engr.mohamed ehab
there is 13.8 KV (medium voltage) in Saudi Arabia and also
the 3 phase volt is 380 or 4oo or 440 or even 220 and 110
all of this aren't able to be divided by 11 so its not a
certain condition but its a standard values which is
unanimous by all engineering associations
Is This Answer Correct ? | 4 Yes | 17 No |
design a LV scheme for a 15 storied building?
how to calculte capacitor range for single phase induction motors??pls tel
if field breaker of generator is closed prior to its rated speed on a power generating unit. what will be the effect on generator, unit transformer and starting transformer.
what is cathodic protection and why it use in industries?
defination of loads
how to setting voltage RTCC panel
in the Distribution system .which one is Most Economically used by Power Engineer ? a)3 Phase3 wire System or b) 3Phase -4wire System
Why VCB is required and ACB is also require? what is the BDV of Trafo of 11/33 KV
in our transmisison sub station why we step down firstly 132kv\33kv then 33kv to 11kv. can we direct step down 132kv to 11kv.
which relay is better , instantaneous or IDMT relay .
Is it possible to measure correct value of earth resistance & cable insulation ristance with out disconncting earth lead & both sides of cable ends? If not, any other method to measure ER & CIR with out disconneting from the system.
What is primary distribution and secondary distribution of ac power?