Answer / eduardo

I don´t know. Nobody knows.
The current flow depends the voltage and the impedance of
the circuit, according the Ohm law.
If the impedance is infinite (open circuit) there is no current.
If the impedance are equal for both lines then in accordance
with Ohm law the 110kV line will have the greater current flow.

Answer / saravanan

11kv line because high voltage cureent is saturated

Answer / nishant vadhavana

Fault current depends upon voltage & impedence of current
path. Assume any particular value say Z for impedence,then
for higher the voltage voltage more the fault current -
fault MVA.

Answer / jkth

the potential difference between 110kv to ground is grater than 11kv to ground.

Define filter?

0 Answers  

---

c. int m = 10; main() { int m = 20; {int m = 30;} printf("%d %d",m,::m); 1. 10 10 2. 10 20 3. 20 10 4. 20 30 5. 30 20 6. None

2 Answers  

---

What are the neccessary safety arrangements before commissioning of HV substation?

1 Answers  

---

We are having Chemical earthing pit the voltage between neutral to earth showing 22V how to solve that

4 Answers  

---

phase association of 3PH L&T static CT meter is wrong. means 1PH & 1 CT connected properly and other 2 voltage and CT's inter changed. what would be the impact in the reading?

3 Answers   KSEB,

---

Why inverter rating in KVA?

3 Answers  

---

IN 6.6KV 3 phase switch gear .i will give 6.6kv to R phase only to earth in during H.v testing (through H.v KIT).what happen remaining phases.how much voltage get remaining phases.why? explain.

1 Answers  

---

if the armature current in a dc generator is ac ( sinusoidal ) why doesnt the sjhape af armature mmf a sinusoidal (ni) ? armature mmf in case of a dc machine is triangular.

0 Answers  

---

Ash AAAC conductor is used for which KV lines

1 Answers  

---

Mention the methods for starting an induction motor?

0 Answers  

---

where we use zero sequence current transformer or core balancing ct.

2 Answers  

---

In a simple spur gear train, gears with 24, 48, 32, 72 and 96 teeth are in sequence. The gear with 24 teeth runs at 900 rpm. The speed in rpm of gear with 72 teeth is

1 Answers   Caterpillar,

---