what is the calculation involved to
design the heater to heat 10KL of water
in temperature control unit?
No Answer is Posted For this Question
Be the First to Post Answer
mostly the questions were from machines... d.c. machines, transformer, synchronous and induction all theory paper........ few from power system... but the level of paper was easy.....
according to ohms law ,the voltage increases then current is what happened?
mccb service sittings be done?
Why 15Amp. MCB is suitable to carry load of 1.5Ton Ac please Explain?
75kw drive operated motor current fluctuation from(85-130)ampere.current setting in drive is 130amp.sometimes motor trip when current limit cross 130amps.I change the drive. still current fluctuate between 80-130amps but in this time motor not trip,current setting in drive is 130amps.where is the problem?
which tap of the transormer you will use in critical condition(worst)?
what is the means of dedicate earthing?
How can you calculate the size of the down conductor cable for the lightning protection system. Is 70mm2 cable can replace 95mm 2 bare copper cable when the copper tape size is 25Wx3 thk mm.
Why neutral is not used in three phases dol starter
what is meant by differential protection of transformer
How to calculate load requirement of a 50 flat apartment with 5 kw each unit,sizing of cable,transformer
what's the difference between ATS and AMF...??pls answer me in detail with its working principle and construction also..
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)