Transmitter reading is zero but in DCS showing one Bar what is the reason ?

Question Posted / kochu

3 Answers
7866 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

Transmitter reading is zero but in DCS showing one Bar what is the reason ?..

Answer / parmi

In dcs lrv is 1bar

Is This Answer Correct ?

11 Yes

3 No

Transmitter reading is zero but in DCS showing one Bar what is the reason ?..

Answer / atul bharadiya

in field measuring unit is BARG & dcs Unit is BAR A,means
gauge & absolute pressure

Is This Answer Correct ?

2 Yes

1 No

Transmitter reading is zero but in DCS showing one Bar what is the reason ?..

Answer / palanikumar

1. check the range LOW LIMIT in DCS . its may be more than one bar.
2. check the isolator or spiliters if anything between DCS and transmitter.

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Instrumentation Interview Questions

How to calibration coriolis flow meter?

0 Answers

in a electronic controller why we are using 250 ohm resistance in input signal?is i/p is necessary in control valve when we are using electronic controller give details?

3 Answers IOCL,

In my plant I want to mount a steam flow transmitter .Flow nozzel is already mounted in steam line .So how can i know the range to put in flow transmitter?

1 Answers

How to make position transmitter feedback reverse i.e at valve close i want 20ma output and at full open 4ma.for the NELES positioner,model:ND8261/TS1.

3 Answers

Please can anybody tell me the step by step procedure for calibrating the Pr,Lvl,Fl,Temp transmitter on process?

1 Answers

What is motion balance principle?

0 Answers

Calibration procedure for water rotameters

0 Answers HPCL,

why 4 to 20 ma used at 0 set

2 Answers Borouge, Yokogawa,

What is seismic transducer?Where it is used?

1 Answers

1. what is 3 point calibration & 5 point calibration? 2. If we use hart communicator to set the LRV & URV of a smart transmitter, did we calibrate the transmitter? why? 3. Make a complet list if meterials needed to properly connect a pressure gauge to a steam pipe using 1/2 inch stainless steel tubing. The gauge connections is 1/2 inch NPT-M and the steam pipe tap has a 1/2 inch female coupling, compression fittings are use. 4. What are the tools in loop checking? 5. What would the ISA symbol of a square root extractor look like? 6. What would you do to completely prepare for the configuration? 7. What safety measures must you undertake when doing configuration? 8. what are the two most commonly use programming languages used when we configure a PLC? 9. What would you do if you accidentally skipped a step in the configuration procedure? 10. How would you know if the configuration were sucessful? 11. Name at least 3 selections available when we configure the burnout protection of a controller?

3 Answers EI Electrotechnical Institute,

IF PLC POWER FAILURE THEN WHAT HAPPEN?

2 Answers IFFCO,

selection criteria of control valve? and selection criteria of actuator explain in brief?

0 Answers

For more Instrumentation Interview Questions Click Here