Answer / jayanta

biasing is a process of connecting dc voltage to a device
by which we can select the operating point of the device.
by biasing actually we select the operating point of the
device.

Answer / khaja pasha

Biasing is defined as the when the electrical energy
applied to the pn junction it cancels the potential barrier
is called biasing.

Answer / giri babu

Biasing means supplying DC energy to active devices(PN
diode,BJT,JFET,MOSFET)so that they starts functioning to
serve the desired purpose.(their junctions can be reverse
or forward biased accordingly.)

Biasing is the means of selecting an operating point of
active device,from which it starts working(either as an
amplifier or an Oscillator) on excitation of input
information.[ofcourse,for oscillator there is no input(DC
is the only source)under which it has to be oscillated
(gives time varying signal)from Dc.]

Biasing MUST be done to active device such that the
selected operating point should be STABLE.

Answer / kumarv

biasing is applying the potentilas from the battery to
devices.(PN,PNP,JFET).it can be forward or reverse.

Answer / abdul mateen

actually PN junction is nothing it works only if we connect
it with the two terminals of the battery and provide it a
fixed DC current or voltage to perform a specific task and
that is called biasing in brief biasing can be farward
biased or reversed biased

Answer / megaraj begam

supplying external voltage by a battery to the DIODE or
TRANSISTOR is called biasing

Answer / yogesh

Biasing is the way by which we can bring the semiconductor
device from passive mode to active mode.

Answer / punit

biasing is a dc voltage applied to any active semiconductor
device like PN diode, BJT, JFET, MOSFET etc.. to come in to
work

Answer / sonia

Biasing means to apply a voltage for conducting diode.It
should be forward or reverse biasing depends upon voltage
polarity.

Answer / veeranna.hooli

biasing is defined as the when the electrical energy applied
to the pn junction it cancels the potential barrier is
called biasing.

OR

And also when we put substrate voltage that time that gate
vt is change so It's called biasing.

What is VSWR? what are waveguides and their types. What is Aloha? Shannon's information capacity theorem, Sampling theorem, antenna gain, types of antennae, GSM/CDMA comparison, modulation techniques, Superheterodyne receiver

2 Answers   Ericsson,

How receiver detect that which is information signal and which is carrier signal and how it seprate both at destination?

4 Answers   Airtel,

Usually we say that capacitors block dc and allow ac. if a capacitior is connect in series with a resistance.. will current pass through the capacitior.... if i doesn't pass..is it due to offering of infinite resistance by capacitor there by acting as a open....

1 Answers  

Why series inductor and l-section filters cannot be used with half-wave rectifiers?

0 Answers  

Y did u select he engineering?

4 Answers   TCS,

Name some of the voltage driven (voltage controlled) devices?

0 Answers  

what is the meaning of 8051 microcontroller

4 Answers   ONGC,

Compare and Contrast- Diffusion and Drift Mechanisms

0 Answers  

How the active power factor correction changes the wave shape of current drawn by a load to improve the power factor?

0 Answers  

What does a tristate signal in electronics signify?

0 Answers  

What is meant by impedance diagram?

0 Answers  

master slave flipflop stores how many bits at any instant?

1 Answers   Ecil,