Answer Posted / yogesh
Biasing is the way by which we can bring the semiconductor
device from passive mode to active mode.
| Is This Answer Correct ? | 7 Yes | 4 No |
Post New Answer View All Answers
What are the control strategies of chopper?
What is single input output interface? How it is different from single ended interface?
IN A PN JUNCTION DIODE,( ON FORWARD BIAS ) WHEN ELECTRONS AND HOLES PAIRS MADE AND CURRENT FLOWS,THEIR IS NO END OF ELECTRONS AND HOLES IN A LITTLE SEMICONDUCTOR DEVICE.
What does a tristate signal in electronics signify?
What is the difference between d-latch and d flip-flop?
can you give me example of igbt drive circuit... i still not under stand how it can be design with certain equation using mathlab program...
Define what is photodiode?
Is it possible to isolate a drive by installing a offline ups and also drive should be protected during normal power supply availability and is the use of isolation transformer necessary.
Explain why we are using the bridge rectifier in most of the circuits instead of full wave rectifier even though the output of both are same?
Indicate the various quantities that can be measured with a multimeter.
What logic function is obtained by adding an inverter to the output of an and gate?
What is the importance of if in radio receiver?
Why vestigial side band is used in tv signal transmission?
Explain why the shape of op-amp is triangular not other shape?
What are chebushev filters? Explain?
