Answer / karthik pissey

Biasing in electronics is the method of establishing
predetermined voltages and/or currents at various points of
an electronic circuit to set an appropriate operating point.
The operating point of a device, also known as bias point,
quiescent point, or simply Q-point, is the point on the
output characteristics that shows the direct current (DC)
collector-emitter voltage (VCE) and the collector current
(IC) with no input signal applied. The term is normally used
in connection with devices such as transistors.

Answer / mr.mime

biasing is applying a correct voltage to a circuit to be
able to conduct!


SORIANO PO! PROF NAMIN!

Answer / rajasekar

The proper flow of zero signal collector current and the
maintenance of proper collector emitter voltage during the
passage of signalling is known as biasing

Answer / preethi

Biasing is defined as to stabilize the operating point by
apply a external current or voltage to a circuit.

Answer / shiwani singh

The proper maintainence of collector current and emitter
base voltage during the passage of signal is caleed biasing.

Answer / deepak sapkota

Biasing is the way of connection of the pn junction diode
(or any other diode or trangistor or fet etc)to the applied
dc potential. so there are two tipes of biasing mainly
forward biasing and reverse biasing.

Answer / veerababu

the process of applying dc voltage any terminal of transistor

Answer / annsh verma

appling external dc voltage to any electronic device is
called biasing as seen there is no current in the unbiased
pn junction

Answer / bajrang kumar

Biasing is a process of established connection between two electrical component which exchange energy may be electric current ya other energy

Answer / vasim khan

biasing is the way of connection of dc voltage i.e, forward
or reversed bias connection to the terminals of pn diode,
BJT , JFET, MOSFET...!

how do link aT1 from the 1st BTS to 2nd BTS4?

0 Answers   Ericsson,

describe the bandwidth delay problem?

1 Answers   Hathway,

How many TRXs are supported in Nokia Metrosite

0 Answers   NSN,

what is meant by q factor of inductor?

5 Answers   GE,

previous rrb secunderabad exam papers with solutions?

59 Answers   College School Exams Tests, EEE, FIC, IBM, Renuka Plastic Craft, RRB, TC, TCS,

Explain why the feeding frequency to a microprocessor is twice the operating frequency?

0 Answers  

A half wave rectifier is used to supply 50vdc to resistive load of 800ohms the semiconductor diode has a forword resistance of 25ohms,calculate ac voltage required?

1 Answers   TCS,

write a program that changes 74H to 47H in 8085 assembly programming

0 Answers  

trains run on ac or dc?? if ac or dc what are the advantages and disadvantages?????

4 Answers   ABB, Infosys,

What is "Aging effect" in B.J.T. ? please mail the answer at my ID, which is- kuldeeptiwarit@gmail.com

1 Answers   DRDO,

Draw the current Vs time graph for an inductor connected to a d.c. source. How will you measure power of a transmissioon line? Tell all the steps alongwith the components used in power generation. Which law governs the induced emf?

0 Answers   Bhel,

i want do telecom protocol development course from hyderbad convergence training school so what is the scope after doing that course and will i get a good job after doing the course and what will be the minimum package

0 Answers   BSNL,