Answer / robin

Top Bar should be lap at Mid span and Bottom bar shall be
lap at one third of span distance from support

Answer / debashis.mondal

Yes

Which standard describes the tolerance limit for undulation of RCC wall/ after POP surface?

1 Answers  

---

what r the precaution for high in atp tempareture,low in atp tempareture

0 Answers   NSL,

---

how to calculate rate analysis for column shuttering

2 Answers   L&T, Marg,

---

difination of civil engineer

1 Answers   Reliance,

---

what is mean by bleeding of concrete

4 Answers   Afcons, Habib Group,

---

What is the standard size of a brick used in North India?

3 Answers  

---

What is the difference between tor steel and tmt steel?

0 Answers  

---

how many brick in 1 cubic meter with mortar ?

9 Answers   Electrical, SV,

---

For submitting the project loan for bank Residential bldg,Suppose we take Provinding RCC mix 1:2:4 for footings No of footings,length ,Breadth,Height ,qty in cum, at last unit/Rate(Rs) ,i would like to know how do we get the unit/Rate

0 Answers  

---

What is the amount of cement,sand and course aggregate(jully)(in kgs) required for the RCC of an area of 450 square feet and 5 inch depth if the concrete mixing ratio is 1:2:4(cement:sand:jully)?your answer will be very helpful.

1 Answers  

---

Providing cement based water proofing treatment to terrace (Indian water proofing) with brick bats with cement morter (1:5) and (1:3). what are rate in cum or sqm.

3 Answers  

---

how much quantity of cement and sand required for construction of 10 cum brick work( Brick size 3"*4"*9"(Standard size ) an d for 10 cum construction of SSM (Size stone masonary) with Cm 1:6 for both.

11 Answers   GRC, KEC, L&T, Techno Electric and Engineering, UPENN,

---