what is diff between auto level and dumpy level?

Answers were Sorted based on User's Feedback



what is diff between auto level and dumpy level?..

Answer / ashit

For an auto level,bubble can be adjusted from any angle and
from any side but in dumpy level,for levelling of bubble
first u have to keep bubble parallel to two levelling screws
and then right angle to third screw.

Is This Answer Correct ?    171 Yes 31 No

what is diff between auto level and dumpy level?..

Answer / sagar sontakke

Above answer is partially right.Major difference between these two is, in auto level readings are actual as staff seen from the eye piece is straight where as in case of dumpy level staff is inverted so that we have to adjust the readings accordingly.

Is This Answer Correct ?    104 Yes 21 No

what is diff between auto level and dumpy level?..

Answer / kabilan m

in dumpy level we have to adjust the bubble level as said above.  
and
in auto level there comes a internal compensator mechanism (a swinging prism) which takes care of adjusting the line of sight, so no need of leveling the bubble. it is most preferred in road construction... 

Is This Answer Correct ?    40 Yes 9 No

what is diff between auto level and dumpy level?..

Answer / chattu

auto level are shown down to uper level reding but dumfy level ar shown uper to down lavel .

Is This Answer Correct ?    2 Yes 1 No

Post New Answer

More Civil Engineering Interview Questions

what is pile foundation?

54 Answers   HDIL, Nishu Group,


How to fix toll charge for a particular vehicle at toll booths in a highway?

0 Answers  


What is the proportion of cement agg. and sand for M20,M25 and M30?

12 Answers  


HOW TO DETERMINE FOUNDATION DEPTH OF A MULTYSTORIED BUILDING. IS THERE ANY OTHER FORMULA EXCEPT RANKINE'S MINIMUM DEPTH FORMULA.

1 Answers  


rate analysis hiring of generator 62.5 KVA

0 Answers  






Diagonal check is required for a layout work to confirm ––

3 Answers  


What is the difference between Rock And Murrum. How to claim that excavated material is not a murrum but rock.

0 Answers   MTC,


we have a texmo make submersible water pump 5hp 10 stage what will be the total head & is it any thumb rule for calculating the head please reply urgently

3 Answers  


how calculate bench mark errors

2 Answers  


Suppose a new brick wall is being constructed,and the courses and not aligned horizontally,what negetives can it cause?

0 Answers   Bhel,


What is the amount of brick in cum we get in a BIG LORRY approx ??

3 Answers   Pegasus,


Explain what is zoning permit?

0 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4452)
  • Electrical Engineering Interview Questions Electrical Engineering (16636)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)