what"s the formula to calculate the water for M15 grade concrete?

4 Answers  

---

how to calculate cut length of for a triangular portion for steel ?

0 Answers   Shashi,

---

What are the Design Mix proportion,and where they are used

4 Answers   Unicel,

---

ratio 1:4:8: for pcc. area 1008 cft. thickness 6' what is the quantity we need

2 Answers  

---

silt%= silt volume/ silt+sand volume is this right?

0 Answers  

---

What you understand by building codes?

0 Answers  

---

How manu days after the casting of a slab another slab can be casted above it? what is the total curing time of a slab if ponding is not done on it?

6 Answers  

---

1.DIFFERENCE BETWEEN NOMINAL MIX AND DESIGN MIX? 2.WHAT IS MEANT BY STRUCTURAL DESIGN? 3.IN STAAD WHY WE RELEASE MOMENT TO A MEMBER? 4.ON WHAT BASIS PARTIAL FACTOR OF SAFETY ARE DECIDE?FROM THE LOAD COMBINATION? 5.WHY WE PROVIDE EXTRA BAR & DEVELOPEMENT LENGTH AT TOP? 6.FULL FORM OF SPT & SMB? 7.WHAT IS MEANT BY ITP IN A CONSTRUCTION PROJECT? 8.WHAT IS LEAST COUNT OF THEODOLITE SURVEY? 9.WHAT ARE THE CAUSES OF FAILURE OF FOUNDATIONS AND REMEDIAL MEASURES? 10.WHAT ARE THE VALUES OF COMPRESSIVE STRENGTH? 11.STEEL CALCULATION FOR FOOTING,BEAM & SLAB? 12.WHAT IS MEANT BY GANTRY GIRDER? 13.IN SITE HOW WE CAN IDENTIFY THE ONE WAY, TWO WAY SLAB? 14.DIFFERENCE BETWEEN ANCHORAGE LENGTH & DEVELOPEMENT LENGTH? 15.BEARING CAPACITY OF STEEL SHUTTERING?LOAD CARRYING FOR SHUTTERING?

3 Answers  

---

A sieve analysis results in 100% retained in no. 50 Sieve, the fm is?

0 Answers  

---

what is Brest Wall?

0 Answers  

---

What is the difference between gray swr pipe & red swr pipe

1 Answers  

---

How calculate the physical stock of material such as Fine/Coarse aggregate,sand & stone dust laying at site?

3 Answers  

---