What will happen to magnitude of voltage of other two phases if one phasw will

What will happen to magnitude of voltage of other two
phases if one phasw will touch the ground?

Question Posted / shaheer ap

3 Answers
6313 Views
Construction, NPCIL, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

What will happen to magnitude of voltage of other two phases if one phasw will touch the ground?..

Answer / mohan

then it will be lg fault so arcing grounds will produce. so
voltage of the healthy phases become root three times of
phase voltage

Is This Answer Correct ?

2 Yes

0 No

What will happen to magnitude of voltage of other two phases if one phasw will touch the ground?..

Answer / k.prakashchandra

They remain unchanged.

Is This Answer Correct ?

1 Yes

4 No

What will happen to magnitude of voltage of other two phases if one phasw will touch the ground?..

Answer / shaheer ap

It is L-G fault . Hence I think we can find solution by dividing circuit in to three sequence network , ie Zero, positive and negative sequence networks..

Is This Answer Correct ?

2 Yes

5 No

Post New Answer

More Electrical Engineering Interview Questions

why rms value of voltage is fed to transformer

1 Answers Bhel,

What is an ideal transformer?

0 Answers

what is single turn and multiturn encoder ? Can single turn encoder be used to show rpm of a motor(on shaft) ? Plz explain in brief .abanirout@gmail.com

1 Answers

what is RTU with SCADA connection ?

2 Answers

one 60KVA UPS how can full load current tell me us formulas

1 Answers Wipro,

what happens if DC earthing and AC earthings are shorted?

1 Answers

What is transformer break down voltage.And what is flash oil flash point.

1 Answers HP,

What is the 415V AC Soft starter? Explain with an example?

1 Answers TCS,

how to calulate multiplying factor if meter ratio is /5 ampere and ct ratio is 100/5 ampere.(our supply is 3 phase 415 volts)what is multiply factor?

3 Answers Vivek Engineers,

Three set (each phase contain 2 cable of 400 mmsq CU XLPE AWA) of single core cables are connected to 11 KV motor of 14 MW & the switch gear supplay is taken from 11kv feeder & this supplay taken from 275 KV substation. Problem is one pair cable(L3- 2 cable ) getting very hot & gland melted and damaged in switch gear side. the other two cable haven't any more hot(ambient temp only & L3 haveing 95- 100 Degree C. The same problem happened in 275 KV substation switch gear side also where the supply taken for 11 kv switch gear. But here L2 phese cable had problem. Why it is happening like this?. The cable having temperature different at different location from gland side inthe case of 11KV feeder of 275 kv substation. why ?

2 Answers

what is the relation bw voltage and F in capacitor?

3 Answers TATA, Tata Motors,

How will be the single line diagram of series trip HT breaker? how it works?

0 Answers HAL,

For more Electrical Engineering Interview Questions Click Here