Answer / sriram

50 X DIA OF BAR

Answer / ilavarasan.g

50xd

Answer / bilal ali khan

lap lenght is the length of bar to be overlap on other that is ld
for fe500 ld is
m40-36d
m35-40d
m30-46d
m25-49d
m20-57d
for fe415 ld is
m40-30d
m35-30d
m30-38d
m25-41d
m20-47d

Answer / munesh natrrajan

When the Length of Bars available in the market is many
times smaller than the length required or when pieces of
bars are to be utilized,the bars are required to be lapped
that lapped length is called lap length.

Lap length will be as follows;

Tension - Ld or 30 x diameter of bar,whichever is greater.

Compression - Ld or 24 x diameter of bar,whichever is
greater.

Answer / arun

when the rod is 12.12M .but length of building height is
higher than 12.12m we are provided in lap length.

it is depending upon the rod diameter.

Answer / erlk

lap length is Depending upon Types of Concrete.
Dia of Steel Bars

Answer / vijay

l/5

Answer / ravi bhatia

49 x d for M-25 concrete mix
57 x d for M-20 concrete mix

why we are using 190x90x90 mm of brick size?

3 Answers   HCL, MPSC,

how to nfind out the specific gravity of sand.aggregate,water please help...

0 Answers  

Rate analysis of Design mix concrete M50 and M60 DMRC

0 Answers  

Civil engineering material testing Standard results

0 Answers   SUCG Infrastructure,

what is the difference between stress and pressure??

7 Answers   Rites,

Explain the design for rcc multi-storied building?

0 Answers  

how many area req.in 15000liter water tank

7 Answers  

minimum number of bars in a beam? minimum and maximum column size and beam size ? minimum and maximum aggregate size used in multistorey residential building for columns,beams,slabs?

0 Answers   bscpl,

The portion of a brick cut across the width is called?

0 Answers  

What is plasticiser and where it will use?

2 Answers   Simplex,

DEFINATION OF CIVIL ENGINEERING

13 Answers   HCC,

i) Distinguish between Theodolite and dumpy Level? (Marks-8) ii)Distinguish between Viscous and Turbulent flow? (Marks-8) iii) Distinguish between nominal and design mix? iv) What is standard sand? v) Explain the term plane stress? Vi) Differentiate between principal plane and principal axis? Vii) write short notes on Elastic limit of structural steel? viii) Write short notes on stress concentration? ix) write short notes on "Grading of Sand" ? x) How many grades of concrete are there under standard concrete?

0 Answers   Public Service Commission,