Why we are not placing c.B 's btwn generator and transformer.? what happen

Why we are not placing c.B 's btwn generator and transformer.?

what happens when generator gets disconnected from
transformer when it is running @ full load?

Question Posted / raj

3 Answers
6565 Views
Areva, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

Why we are not placing c.B 's btwn generator and transformer.? what happens when generator get..

Answer / selvakumar.t

When generator breaker opened at full load. Subsequently the
generator prime mover will go to over speed.We can use place
the breaker between generator and transformer through bus
bar. Because transformer was transmitting the power only.

Is This Answer Correct ?

2 Yes

1 No

Why we are not placing c.B 's btwn generator and transformer.? what happens when generator get..

Answer / e.subhash

Not necessary, because generator is synchronising hence we need bus only.

Is This Answer Correct ?

0 Yes

0 No

Why we are not placing c.B 's btwn generator and transformer.? what happens when generator get..

Answer / pallab phukon

when a generator is disconnected from supply when it is
running at full speed,there will be mechanical vibration in
the rotor and may even break.so,if a generator should be
disconnected,we have to at first reduce the load.

Is This Answer Correct ?

1 Yes

4 No

Post New Answer

More Electrical Engineering Interview Questions

last week we did the REF relay test by closing single pole (R phase) of CB and apply 380V at the primary of delta transformer. we get 33A at the primary of the R phase star end. but we get 380A at both R an B in delta side. how and why?

1 Answers Siemens,

what is the profesional board for electrical engineer what is thepast and during construction for electrical engineering

0 Answers

how much battery need for 2kv online ups for 2hr backup

3 Answers Eaton, Emerson,

why transmission is done in delta system

4 Answers

Which is the oldest hydropower plant in india?

0 Answers

why transformer does not obey ohm law?

27 Answers

We are getting supply at33kvand it stepdown to 11kv.So Our requirement is 11kv voltage.why we draw 33kv from the grid instead of 11kv?

2 Answers Birla,

1.What is the difference between isolators and circuitbreakers? 2.What is bus-bar?

1 Answers

how to reduce earth resistance in sandy soil.

1 Answers

how we can calculate power factor in single phase & three phase ?thank u

0 Answers

Some times to change of DOR of a motor, interchange of R & B is not effected and RYB take same current, but interchange of R&Y is effected ie change the DOR. My doubt is what is the problem in motor and how it is happen.

0 Answers

How can we calculate ngr resistance for a generator and Transformer ? What type of transformer requires ngr ?

5 Answers Welspun,

For more Electrical Engineering Interview Questions Click Here