Interested to Buy Any Domain ? << Click Here >> for more details...
Why we are not placing c.B 's btwn generator and transformer.?
what happens when generator gets disconnected from
transformer when it is running @ full load?
- 3 Answers
- 6558 Views
- Areva, I also Faced
- E-Mail Answers
Answer Posted / selvakumar.t
When generator breaker opened at full load. Subsequently the
generator prime mover will go to over speed.We can use place
the breaker between generator and transformer through bus
bar. Because transformer was transmitting the power only.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
What are the different types of controllers?
can we synchronize star system generators with delta system transmission line ? and how ?
bus bar design conditions and sizing pls tell me quickly
How would you calculate power loss in a resistor?
can u describe the method used for protection of transmission line.
why do we not use equivalent voltage source in negative sequence equivalent ckt.
why should the primary of transformer be connected in delta in a heat run test?
In general bus riser follows the bus section in SWGR. What are impacts if bus section follows bus riser?
when we decide to use soft starter drive or vfd drive in mcc to operate apump?
What is the necessary condition for stability.
What the formula for calculating no.of earthings & size of earth strip for 100mX90m shop.
How to set a Zone 1 distance relay for distribution feeder?
sir, i'm preparing for hpcl exam officer trainee pls tell me how the exam ques paper pls pls
What will happen if a dc source is given to a tubelight. Will it work or wont it work....
what is meant by poly phase induction motor ? how its operating by single phase or three phase?
