Why does not AC excitation use in rotor of AC Generator
instead of DC excitation?
Answers were Sorted based on User's Feedback
actually in rotor of ac generator we require fixed
alternate north and south pole for generation of ac, theese
are electomagnet.theese poles are acheived by direct
current bcz in case of ac pole changes there polarity in
each half cycle.
| Is This Answer Correct ? | 1 Yes | 0 No |
Answer / sanjeev parekh
because the rotor of ac generator is of salient pole design
which generates fixed north & south poles and thus fixed
direction magnetic field not pulsating magnetic field.
While rotating are cut by stator conductor generating ac
voltage.
| Is This Answer Correct ? | 2 Yes | 2 No |
flurescent bulb rating is to 230v,50HZ.now flurescent connected 230v,25HZ.whether nreduced frequency will affect the glowing properties of flurescent.
why use delta star x-mer in distribution system.
WHAT IS VCB SAFETY
How to calculate earth flat size for 250 Kva DG and transformer?
advantage of motor design on higher power factor . normally motors are designed for .8 power factor. what is advantage of designing at .88 power factor
what are the advantages by using IGBT in VSC HVDC than thyristor in conventional HVDC
A 11 KV motor is working. if the supplay is fail. what will happened with it's breaker? Trip / remain the same condition?
What is rotary phase converter?
What are the types of windings present in the ceiling fan? What winding will be effective first when we started the fan?What are the resistance and inductance ratios comparatively at the initial speed and full speed of the fan?
how to crack cgpsc,which type of knowledge it is required,where i can get systematic study material and some tips?
Why we check only first column of root locus..?
my question is that....few days ago i had installed a three phase motor starter for an electric saw.the motor will run and make the hydraulic pressure which will be goes to pressure cylender by up and down lever.two number of limitswitches are also installed on cylinder for safety of motor.now when the arm of cylinder reaches to the upper or lower limit it will cut the motor's line.and motor will be stop.now wana know that what will i do that motor runs continue after the limitswitch cut it down but it shold not be made any pressure.pls answer me in brief.
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)